Results 91 to 100 of about 418,203 (210)
The role of freestream turbulence scale in subsonic flow separation [PDF]
The ojective of this work is the clarification of the role of freestream turbulence scale in determining the location of boundary layer separation. An airfoil in subsonic wind tunnel flow is the specific case studied.
Barnett, R. J. +3 more
core +1 more source
Journal of Engineering and Sustainable Development, 2018 The combined effect of wire coil with twist tape inserted in a circular tube using hot air as the test fluid on heat transfer rate and pressure drop were investigated experimentally.
Hisham Assi Hoshi
doaj
Measurements of flow phenomena induced by suction through perforated and partially plugged surfaces [PDF]
Efforts were directed towards completing construction of the windtunnel test section, assembling instrumentation, programming the data acquisition and reduction system, adjusting the streamwise pressure gradient of the test section, calibrating the hot ...
Goglia, G. L., Wilkinson, S. P.
core +1 more source
Analysis on Surface Cracks of Martensitic Steel 40Crl0Si2Mo Wire and Process Improvement
Teshugang, 2020 After quenching and tempering, straightening and grinding, the surface cracks are found on the polished rod surface of steel 40Crl0Si2Mo 6. 5 mm wire rod.
孙增淼 +5 more
doaj
Hot-Wire Attenuation and Its Correction in Turbulence Measurements [PDF]
, 2007 A scheme is proposed for correcting the hot-wire attenuation in turbulence measurements in both frequency and time domains. The scheme is tested for simulated hot-wire signals under velocity impulse and sinusoidal perturbations of various frequencies. It
Li, Jun-De
core +1 more source
Development of subminiature multi-sensor hot-wire probes [PDF]
, 1988 Limitations on the spatial resolution of multisensor hot wire probes have precluded accurate measurements of Reynolds stresses very near solid surfaces in wind tunnels and in many practical aerodynamic flows.
Lemos, Fred R. +2 more
core +1 more source
Optimizing the Parameters of Hot-wire CNC Machine to Enhance the Cutting of Plastic Foam
Al-Khawarizmi Engineering Journal, 2019 Hot-wire cutting is one of the important, non-traditional thermomechanical way to cut polymer, usually expanded foam and extruded foam, in low volume manufacturing.
Israa Q. Mohammed, Ali H. Kadhum
doaj
Experimental investigation of flow over a backward facing step-progress report [PDF]
The sizes and arrangement of the wind tunnel used for the experimentation are described. The specifications for the cold-wire anemometers, hot-wire anemometers, cold-wire rakes, and miniature 3-wire probe are proveded.
Browne, L. W. B.
core +1 more source
Shearing-Stress Measurements by use of a Heated Element [PDF]
, 1954 The rate of local heat transfer from a solid surface to a moving fluid is related to the local skin frinction. Measurements of the heat transmission from small elements embedded in the surface of a solid can thus be used to botain local skin-friction ...
Liepmann, H. W., Skinner, G. T.
core +1 more source
The Hot-Wire Process for Zirconium
Journal of The Electrochemical Society, 1952 R.B. Holden, B. Kopelman
openaire +2 more sources