Results 11 to 20 of about 418,203 (210)
Investigation on Characterizing Heated Pulsating Flows with Hot Wire Anemometers - A Hands-On Approach [PDF]
INCAS Bulletin, 2014 The pulsating heated flows are traditionally a difficult subject to treat with conventional hot wire or film methods. Special factors that complicate matters are flow reversal and non linear flow effects of vortices and wire probe wake disturbances on ...
Marius Alexandru PANAIT
doaj +3 more sources
The Influence of Si on Microstructure and Mechanical Properties of Hot-Rolled Wire Rods for Cable Steel Wire Ropes [PDF]
TeshugangThe cross section and longitudinal section microstructure morphology of two different Si contents hot-rolled wire rods were observed using scanning electron microscopy and energy spectrum （EBSD） instruments.
Li Jianping, Tang Zhengyou, Zhang Hanwen, Deng Tongwu
doaj +3 more sources
Single-Pass Cladding Process Using Hot-wire Gas Metal Arc Welding Technique [PDF]
MATEC Web of Conferences, 2019 The aim of this study is to improve cladding process productivity by high production rate with low dilution process by specifying technique as hot-wire GMAW process.
Suntiniwat Pattanawit +2 more
doaj +1 more source
Simplified Calibration Method for Constant-Temperature Hot-Wire Anemometry
Applied Sciences, 2020 This study proposes a unique approach to convert a voltage signal obtained from a hot-wire anemometry to flow velocity data by making a slight modification to existing temperature-correction methods.
Hidemi Takahashi +3 more
doaj +1 more source
Metals, 2022 In this work, the effect of the hot dip plating process on the microstructure and properties of zinc–10%aluminum–mischmetal (Zn-10Al-MM) alloy coated for bridge cable wire was studied by changing the hot dip plating temperature, time, and cooling mode ...
Xiaoxiong Zhu +3 more
doaj +1 more source
The response of hot wires in high Reynolds-number turbulent pipe flow [PDF]
, 2004 Issues concerning the accuracy of hot-wire measurements in turbulent pipe flow are addressed for pipe Reynolds numbers up to 6 × 106 and hot-wire Reynolds numbers up to Rew ap 250. These include the optimization of spatial and temporal resolution and the
Jiang, W. +4 more
core +1 more source
Nihon Kikai Gakkai ronbunshu, 2015 In order to investigate the fatigue properties of the fillet welded joint for non-load carrying type using hot-wire laser welding process, fatigue tests were carried out in comparison with the fillet welded joint using CO2 arc welding process to be ...
Hiroyuki AKEBONO +4 more
doaj +1 more source
Journal of Materials Research and Technology, 2022 The microstructure–property relationship of a novel wire rod was investigated after Nb microalloying. The tensile properties were significantly improved.
Jie Zhou +6 more
doaj +1 more source
Assessing Mechanical Properties of Hot Mix Asphalt with Wire Wool Fibers
Advances in Civil Engineering, 2015 This paper investigates the potential application of wire wool in the modification of hot asphalt mixes (HMA). Wire wool material is widely available at local markets as a by-product of wire wool industry and as waste products from homes. For the purpose
Ahmed N. Bdour +2 more
doaj +1 more source
Application of Hot-wire Method for Measuring Thermal Conductivity of Fine Ceramics
Medžiagotyra, 2016 Ceramic substrate is preferred in high density packaging due to its high electrical resistivity and moderate expansion coefficient. The thermal conductivity is a key parameter for packaging substrates.
Shangxi WANG +4 more
doaj +1 more source