Results 51 to 60 of about 418,203 (210)
Analysis on SWRCH35K Steel Wire Rod Cold Heading Cracking and Process Optimization
Teshugang, 2022 The cold heading cracked samples and Φ 12 mm hot-rolled wire rods of SWRCH35K steel are inspected by optical microscope. Analysis results show that the reason for cold heading cracking is full decarburized layer exist on the surface of hot-rolled wire ...
苏振伟 +6 more
doaj
Micro and Nano EngineeringThe miniaturization of sensing elements in hot-wire anemometry through micro-fabrication techniques enables high temporal and spatial resolution, essential for investigating complex and high-speed flows.
Baptiste Baradel +5 more
doaj +1 more source
Study of hot wire techniques in low density flows with high turbulence levels [PDF]
, 1966 Prediction of heat, mass, species, and momentum fluxes in a space vehicle and aerodynamic noise production by supersonic jet and rocket exhausts requires a predictability of the associated turbulence fields. The hot wire is a technique that will allow an
Hanson, A. R. +2 more
core +1 more source
Hot-wire and hot-film anemometry [PDF]
The circuit techniques, electronics, dynamic properties, and the applications of the anemometers are ...
Madsen, B. B., Rasmussen, C.
core +1 more source
Hot-wire anemometry in hypersonic helium flow [PDF]
Hot-wire anemometry techniques are described that have been developed and used for hypersonic-helium-flow studies. The short run time available dictated certain innovations in applying conventional hot-wire techniques. Some examples are given to show the
Wagner, R. D., Weinstein, L. M.
core +1 more source
Asbestos and Inconel combined to form hot-gas seal [PDF]
, 1968 Hot-gas seal prevents warpage tendencies in large flange joints exposed to high temperatures, such as those present in large space vehicle engine exhausts.
Wooster, C. W., Jr.
core +1 more source
Investigation into the Strouhal numbers associated with vortex shedding from parallel-plate thermoacoustic stacks in oscillatory flow conditions [PDF]
, 2010 This paper investigates vortex shedding processes occurring at the end of a stack of parallel plates, due to an oscillating flow induced by an acoustic standing wave.
Jaworski, Arthur J. +2 more
core +1 more source
Amplification of Reynolds number dependent processes by wave distortion [PDF]
A system using a hot-wire transducer as an analog of a liquid droplet of propellant was employed to investigate the ingredients of the acoustic instability of liquid-propellant rocket engines.
Fang, J. C. +2 more
core +1 more source
Application of the Hot Wire Method to Measure the Thermal Conductivity Coefficient of a Gypsum Composite. [PDF]
Materials (Basel), 2022 Powała K +3 more
europepmc +1 more source