A study of the turbulent wake of an airfoil in an air stream with a 90° curvature using hot-wire anemometry and large eddy simulation [PDF]
, 2008 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The broad aim of the work presented in this thesis is to investigate the wake of an airfoil under the combined effects of streamwise curvature and pressure ...
Farsimadan, Ehsaan
core +7 more sources
Using the Finite Element Method to Determine the Temperature Distributions in Hot-wire Cutting. [PDF]
, 2011 Hot-wire cutting is a common material removal process used to shape and sculpt plastic foam materials, such as expanded polystyrene (EPS). Due to the low cost and sculpt-ability of plastic foams they are popular materials for large sized (> 1 m³ ...
Aitchison, David +1 more
core +6 more sources
A global wire planning scheme for Network-on-Chip. [PDF]
, 2003 As technology scales down, the interconnect for on-chip global communication becomes the delay bottleneck. In order to provide well-controlled global wire delay and efficient global communication, a packet switched Network-on-Chip (NoC) architecture was ...
Tenhunen, Hannu +3 more
core +5 more sources
Chemical Engineering Transactions, 2019 Nanofluids (liquid mixtures with a small concentration of nanoparticles in suspension) have unique properties that make them potentially useful for heat transfer applications.
Suren Moodley, David Lokhat
doaj +1 more source
Thermal conductivity measurements of liquids: Challenges and a novel solution [PDF]
Hemijska IndustrijaThis paper provides a concise and accessible overview of commonly used methods for measuring the thermal conductivity of liquids. Both steady-state and transient techniques are briefly outlined, including guarded hot plate methods, laser flash ...
Stanimirović Andrej M. +2 more
doaj +1 more source
Synthesis and characterisation of doped silicon nanoparticles by hot wire thermal catalytic and spark pyrolysis [PDF]
, 2010 Includes abstract.Includes bibliographical references (leaves 94-109).Doped silicon nanoparticles with clean surfaces and which are suitable forelectronic applications, have successfully been produced.
Scriba, Manfred R
core +1 more source
EPJ Web of Conferences, 2010 The transient hot-wire (THW) technique is widely used for measurements of the thermal-conductivity of most fluids and some attempts have also been carried out for simultaneous measurements of the thermal-diffusivity with the same hot wire.
Milcent D. +4 more
doaj +1 more source
Measuring Moisture Content of Wood Using a Transient Hot-Wire Technique
BioResources, 2016 Wood easily acquires a large amount of moisture when it is exposed to high-humidity conditions. The high moisture content influences the service life of wood.
Jingyao Zhao, Yingchun Cai
doaj +1 more source
High-resolution hot-film measurement of surface heat flux to an impinging jet [PDF]
, 2011 To investigate the complex coupling between surface heat transfer and local fluid velocity in convective heat transfer, advanced techniques are required to measure the surface heat flux at high spatial and temporal resolution.
T S O'Donovan +5 more
core +1 more source
Experimental Investigation of Wakes Behind Two-Dimensional Slender Bodies at Mach Number Six [PDF]
, 1967 NOTE: Text or symbols not renderable in plain ASCII are indicated by [...]. Abstract is included in .pdf document. An experimental investigation has been conducted to determine mean flow properties for both near and far wakes behind several two ...
Batt, Richard George
core +1 more source