Results 181 to 190 of about 4,496,230 (391)
The design of an Fe-12Mn-O.2Ti alloy steel for low temperature use [PDF]
An investigation was made to improve the low temperature mechanical properties of Fe-8 approximately 12% Mn-O 2Ti alloy steels. A two-phase(alpha + gamma) tempering in combination with cold working or hot working was identified as an effective treatment.
Hwang, S. K., Morris, J. W., Jr.
core +1 more source
Mechanical Properties of Different Austenitic High‐Nitrogen Steel Grades Produced by Powder Mixtures
Advanced Engineering Materials, EarlyView.The effect of nitrogen content on the mechanical properties of austenitic stainless steels is investigated using tailored powder metallurgical processing. Different PM routes, including additive manufacturing, enable controlled nitrogen uptake and complex geometries.
Felix Radtke +6 more
wiley +1 more source
Laser-heated rocket studies [PDF]
CW laser heated rocket propulsion was investigated in both the flowing core and stationary core configurations. The laser radiation considered was 10.6 micrometers, and the working gas was unseeded hydrogen.
Caledonia, G. E. +4 more
core +1 more source
Advanced Engineering Materials, EarlyView.Fe–12Mn–0.2C medium‐manganese steel is processed by laser‐based powder bed fusion of metals using blended as well as pre‐alloyed powder. Various scanning speeds are used to determine the influence of energy deposition rate on microstructure and mechanical properties.
Leoni Hübner +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Herein, the electroplating of titanium from an organic solvent, ethaline, is shown. Polymer additives are shown to smooth the roughness of the film, and small molecule additives are shown to produce a near‐mirror finish to the deposited metal. Titanium electroreduction is desired for a variety of medical, electronic, and bonding applications but has ...
Steven Livers +7 more
wiley +1 more source
Computer-aided analysis and design of the shape rolling process for producing turbine engine airfoils [PDF]
Mild steel (AISI 1018) was selected as model cold-rolling material and Ti-6Al-4V and INCONEL 718 were selected as typical hot-rolling and cold-rolling alloys, respectively.
Akgerman, N., Altan, T., Lahoti, G. D.
core +1 more source
Direct Natural and Artificial Aging of Aluminum Alloy AlSi10Mg After Laser Powder‐Bed Fusion
Advanced Engineering Materials, EarlyView.Laser powder‐bed fusion of metals aluminum alloy AlSi10Mg has been directly aged. Artificial aging after natural aging is considered. The hardening potential is high for the top part of the samples as well as after short natural aging. The hardening potential is substantially reduced for the bottom part of the samples, as well as after natural aging of
Rabea Steuer +6 more
wiley +1 more source
Experimental study on corrugated plate dryer in steam generator under hot working conditions. [PDF]
iScienceLi R +6 more
europepmc +1 more source
On the High-Chromium High-Cobalt Type Steels for Hot-Working Dies
, 1965 Tomitaka Nishimura
openalex +2 more sources
Advanced Functional Materials, EarlyView.Graded refractive index (GRI) structures are prepared from the layer‐by‐layer spray coating of the mesoporous SiO2 nanoparticles, showing high solar transparency and thermal emissivity. Under outdoor conditions, after 50 days, the GRI‐coated photovoltaics show on average 6.65 ± 1.48 °C lower than that of the non‐coated references, maintaining 80.9 ± 8 ...
Heesuk Jung +14 more
wiley +1 more source