Results 191 to 200 of about 171,115 (218)
Some of the next articles are maybe not open access.
Stresses and strains in multi-filament HTS tapes
IEEE Transactions on Appiled Superconductivity, 1999High temperature superconducting tapes are now commercially available for practical applications such as magnets and cables. However, still today the published data on strength and allowable deformation limits of these tapes are not altogether in agreement. Definitions and concepts with regards to the stresses and strains in HTS tapes under deformation
P. Skov-Hansen, Z. Han, J.I. Bech
openaire +1 more source
Comparison of Overcurrent Responses of 2G HTS Tapes
IEEE Transactions on Applied Superconductivity, 2016<p>In this paper, the comparison of transient responses of second-generation (2G) higherature superconducting (HTS) tapes under alternating overcurrent was presented. The authors performed the series of measurements of the SF4050 and SCS4050 HTS tapes produced by Superpower Co.
Czerwinski, Dariusz +4 more
openaire +1 more source
Characteristics of an HTS Magnet Wound With 12-mm Zr-Doped HTS Tape
IEEE Transactions on Applied Superconductivity, 2014This paper examined the properties of an high-temperature superconducting (HTS) magnet, such as the Ic-B relation and critical current, with pancake windings of a 12-mm-wide Zr-doped HTS tape. Considering the width of the Zr-doped HTS tape was 12 mm, which was three times wider than that of a conventional 4 mm tape, the current distribution at the ...
null Myunghun Kang +3 more
openaire +1 more source
Optimization of HTS Tape Coil Design
2010HTS tapes are promising materials for RF coil due to their advantages of easier fabrication, easier frequency adjustment and lower cost over HTS films. A theoretical model was developed to investigate the relationship of Q with coil size, solder joint and resonant frequency. The model showed that Q increased with size and frequency.
Yuan, J, Wang, C, Shen, GG
openaire +1 more source
Characteristic Analysis of HTS Linear Synchronous Generators Designed With HTS Bulks and Tapes
IEEE Transactions on Applied Superconductivity, 2014Two types of high temperature superconducting (HTS) linear synchronous generators (LSG) have been analyzed, which models developed have either an HTS bulk magnet array or an HTS tape coil as their secondary mover. The no-load induced voltage and output power characteristics versus the trapped flux density of the HTS bulk magnets, the HTS tape coils ...
Zhi H. Wu, Jian X. Jin
openaire +1 more source
A hybrid AC and DC power source for the tests of an HTS tapes
2014 IEEE 23rd International Symposium on Industrial Electronics (ISIE), 2014The structure and the results of measurements of a hybrid supplying system for the tests of an HTS tapes carrying the high amplitude AC current with DC offset is described in the paper. The system is dedicated to an examination of the second generation (2G) superconducting tapes operating under dynamic conditions (the transition between superconducting
Mariusz A. Stepien, Boguslaw Grzesik
openaire +1 more source
Economic prospects for HTS tapes in “magnet” applications
IEE Colloquium on High Tc Superconducting Materials as `Magnets', 1995History should make us very wary of predicting the economic potential of high temperature superconductivity. On the other hand a very substantial amount of money is now being spent on the development of HTS tape and wire by companies who hope to supply the materials for the future superconductivity industry.
openaire +1 more source
Experimental Study on Quench Protection Method for HTS Coil That Uses Cu Tape Co-Wound With HTS Tape
IEEE Transactions on Applied Superconductivity, 2023Ryohei Shimada +6 more
openaire +1 more source
Conceptual Design and Optimisation of HTS Roebel Tapes
IEEE Transactions on Applied Superconductivity, 2022Luning Hao +10 more
openaire +1 more source