Results 21 to 30 of about 215,605 (217)
Computation of AC loss of HTS coils wound by coated conductors with different widths
AIP Advances, 2022 The second-generation high-temperature superconductor (HTS) tape is a promising material for the HTS application. However, the extremely large aspect ratio of the HTS coated tape leads to high power dissipation in the environment of a time-varying ...
Liuyuan Yu, Huadong Yong
doaj +1 more source
HTS-Tape Magnetic Bearing for Ultra High-Speed Turbo Motor
IEEE transactions on applied superconductivity, 2023 This paper aims to design superconducting magnetic bearing using HTS tape for a ultra high-speed turbo motor operating up to $120000 \,\mathrm{rpm}$. Despite being a recent technology compared to conventional magnetic bearings, HTS passive bearings have ...
R. Oliveira, X. Zeng, X. Pei, R. Burke
semanticscholar +1 more source
HTS Tape Mechanical Behavior Sensitivity on Material Properties and Thickness of Material Layers
IEEE transactions on applied superconductivity, 2023 Multilayer 2G high-temperature superconductor (HTS) tapes undergo various mechanical loading steps as part of a superconducting magnet operation. The mechanical loading steps include cool-down to cryogenic temperatures and Lorentz forces when powering up
H. Milanchian +3 more
semanticscholar +1 more source
Applied Sciences, 2023 Superconducting fault current limiters (SFCL) can be an alternative to conventional devices limiting short-circuit currents in power systems. SFCL use high-temperature superconducting tapes of the second generation (HTS 2G) in SFCL, which, after reaching
Sylwia Hajdasz +5 more
doaj +1 more source
Study of HTS Conductors Made From Combinations of HTS Tapes [PDF]
Journal of Physics: Conference Series, 2006 To increase current carrying capacity of an HTS conductor we combined two HTS tapes by soldering or packaging. It permitted to increase current carrying capacity of conductors, while not exactly proportional to the number of tapes used. Slight critical currents reduction is more pronounced for the magnetic fields parallel to the tape's surface due to ...
V E Sytnikov +5 more
openaire +1 more source
3D modeling of a superconducting dynamo-type flux pump
Scientific Reports, 2021 High temperature superconducting (HTS) dynamos are promising devices that can inject large DC currents into the winding of superconducting machines or magnets in a contactless way.
Asef Ghabeli, Enric Pardo, Milan Kapolka
doaj +1 more source
Simulation of Dynamic Resistance and Total Loss of HTS CORC Cables
IEEE Access, 2023 In some high temperature superconducting (HTS) applications, HTS coated conductors carry DC current under external AC magnetic fields. Dynamic resistance occurs when the amplitude of the magnetic field is greater than the threshold magnetic field of the ...
Yukai Qiao +4 more
doaj +1 more source
Magnetization of the stack of HTS tapes
Progress in Superconductivity and Cryogenics, 2015 New results of dependence of magnetic field, trapped by a stack of HTS tapes, on amount of tapes in a stack are reported. Commercial GdBCO tape 12 mm width and without Cu layer was used for the research. Tape was divided in square pieces 12 x 12 mm 2 from which stacks were formed. Filling factor of the tape was about 1.4%. Measurements were carried out
M.A. Osipov +4 more
openaire +2 more sources
New symmetric and lattice shaped high-temperature superconducting coil cross sections
Results in Physics, 2016 To improve the performances of high-temperature superconducting (HTS) coils, it is necessary to store more energy within a shorter HTS tape length and to reduce leakage magnetic fields.
Naoya Uchiyama, Shinichi Ishiguri
doaj +1 more source
IEEE Access, 2023 In the design and prototyping of an Inductive-Resistive Superconductor Fault Current Limiter (IR-SFCL), previously presented by the authors, superconducting screens made from BSCO bulk have been used for shielding the inductive stage of the device.
Alfredo Alvarez +3 more
doaj +1 more source