Hydraulic Device for Simulation of Pressure Shocks
Acta Technologica Agriculturae, 2014 This work is focused on the design of a hydraulic device on which simulations of pressure shocks can be performed. The hydraulic device was constructed to allow simulations of pressure shocks transferred directly in operating conditions because ...
Lindák Stanislav +4 more
doaj +1 more source
Energy harvesting from vehicular traffic over speed bumps: A review [PDF]
, 2018 Energy used by vehicles to slow down in areas of limited speed is wasted. A traffic energy-harvesting device (TEHD) is capable of harvesting vehicle energy when passing over a speed bump. This paper presents a classification of the different technologies
Blanco-Fernandez, E. +3 more
core +3 more sources
Energy-efficient control of pump units based on neural-network parameter observer [PDF]
, 2020 An observer based on an artificial neural network was designed. The observer determines the pumping unit performance depending on the operating point. Determination is based on the measured technological coordinates of the system and the pressure of the ...
Burian, S. O. +4 more
core +1 more source
Characterization of Hydraulic Power in Free-Stream Installations
International Journal of Rotating Machinery, 2017 The performance of open-channel hydropower devices can be optimized by maximizing the product of their load, hydraulic, and generator efficiencies. The maximum hydraulic power theoretically available must be defined according to the operational scenario ...
Olivier Cleynen +2 more
doaj +1 more source
Ultrafast High-pressure AC Electro-osmotic Pumps for Portable Biomedical Microfluidics [PDF]
, 2009 This paper details the development of an integrated AC electro-osmotic (ACEO) microfluidic pump for dilute electrolytes consisting of a long serpentine microchannel lined with three dimensional (3D) stepped electrode arrays.
Bazant, Martin Z. +2 more
core +2 more sources
Learning the basics of a battery pack control system [PDF]
E3S Web of Conferences, 2020 The article discusses the control system of a hydraulic power source of constant pressure, which is a pump-storage power source, equipped with the original design of the automatic unloading of the hydraulic pump, which provides relay switching of its ...
Kobzev Kirill +2 more
doaj +1 more source
Experimental campaign tests on ultra micro gas turbines, fuel supply comparison and optimization [PDF]
, 2018 The increasing demand for miniaturized radio-controlled vehicles inspired the following research. The uses of these unmanned miniaturized/micro vehicles range from aero-modeling to drones for urban control and military applications too.
Capata, Roberto, Saracchini, Matteo
core +2 more sources
OPTIMAL SYNTHESIS OF DRIVE SWING CONNECTIONS OF MOBILE CRANES HYDRAULIC MANIPULATING SYSTEMS
Записки Горного института, 2018 The design, operation features and the optimal design method for the drive swing connections are considered. These are proposed as an alternative design variant of the articulation of adjacent links of hydraulic manipulation systems of mobile boom cranes
A. V. Lagerev, I. A. Lagerev
doaj +1 more source
A Model for Selecting the Most Cost-Effective Pressure Control Device for More Sustainable Water Supply Networks [PDF]
, 2019 Pressure Reducing Valves (PRV) have been widely used as a device to control pressure at nodes in water distribution networks and thus reduce leakages. However, an energy dissipation takes place during PRV operation.
Fernández García, I. +2 more
core +1 more source
Evaluation of ADAM/1 model for advanced coal extraction concepts [PDF]
, 1982 Several existing computer programs for estimating life cycle cost of mining systems were evaluated. A commercially available program, ADAM/1 was found to be satisfactory in relation to the needs of the advanced coal extraction project.
Deshpande, G. K., Gangal, M. D.
core +2 more sources