Results 51 to 60 of about 555 (166)
This study demonstrates that thermally evaporated lithium anodes combined with LiF passivation provide a high‐performance thin anode design for next‐generation ASSBs. This approach increases the critical current density from 1.6 to 2.6 mA cm−2, enabling full cells to achieve over 500 and 300 cycles at 1.5 and 3 mA cm−2, respectively, outperforming even
Jinsong Zhang +4 more
wiley +1 more source
Intrinsic phase toughening transforms a brittle B2 intermetallic into a plastically deformable, load‐bearing phase, while a heterogeneous laminated architecture suppresses strain localization and interface cracking. The synergy between ductile intermetallics and mesoscale heterogeneity establishes a general design strategy for breaking the long ...
Lu Yang +9 more
wiley +1 more source
A Computational Approach for Biomimetic Design of Liver‐On‐A‐Chip
A biomimetic liver‐on‐a‐chip with antiparallel perfusion was designed using COMSOL‐guided simulation to replicate hepatic acinus transport. Full‐scale modelling revealed diffusion‐dominated, length‐dependent nutrient gradients and low‐shear conditions.
Zhenxu Yang +9 more
wiley +1 more source
Microfluidic Valve‐Integrated Garment for Smooth Sequential Gradient Mechanotherapy
We present a soft wearable sleeve that delivers smooth, gap‐free compression using overlapping air‐filled actuators and tiny microfluidic valves. The system reduces bulk, lowers power needs, and uses a smartphone‐sized control box. It can provide sequential gradient compression, gradient pressure holding, and fast deflation, supporting more portable ...
Run Ze Gao +5 more
wiley +1 more source
This work focuses on the investigation of the influence of a long‐time exposition to accelerated thermal aging on the physicochemical structure and properties of PFA. Results show a decrease in the melting temperature and crystal ratio due to chemical aging.
Victor Henri +3 more
wiley +1 more source
Regional gas control scheme and effect analysis
In view of problems of high gas pressure and poor permeability of outburst coal seam, unsatisfactory of outburst elimination effect of regional gas control, slow speed of coal roadway excavation and tension of working face replacement caused by deep ...
HU Zhifang
doaj +1 more source
Feasibility Study of Basic Steel Slag as Anode of Li‐Ion Batteries
This study presents a low‐cost, eco‐friendly approach to utilize basic steel slag as a sustainable anode for lithium‐ion batteries, demonstrating good cyclic stability, rate capability, and long‐term electrochemical performance. ABSTRACT The elevated expenses and utilization of hazardous chemicals in traditional chemical synthesis of anode materials of
Rudra Barua +2 more
wiley +1 more source
An analysis of physical, hydraulic and mechanic properties of nonwoven needle-punched geotextiles
An analysis of physical, hydraulic and mechanic properties of nonwoven needle-punched geotextiles An analysis of physical, hydraulic and mechanic properties of needle-punched nonwoven geotextiles. This paper presents an analysis of technical parameters of needle-punched geotextiles used in engineering constructions.
openaire +1 more source
Review and prospects of shear test of bolted rock joints
The laboratory shear test equipment, test method, and numerical simulation of bolted rock joints were summarized. The shortcomings and limitations of the current research were analyzed, and the research prospects were proposed. Abstract Rock bolting is a critical approach in geotechnical engineering for supporting weak rocks.
Shulin Ren +4 more
wiley +1 more source
Coal seams in China are typically characterized by high coal seam gas content and low permeability, posing challenges for efficient coal seam gas extraction. However, achieving successful boreholes, especially in soft coal formations, remains a challenge.
Shiyao Yu +4 more
doaj +1 more source

