Results 81 to 90 of about 20,193 (267)

Multiscale Modeling of Hole Damage Evolution During Dynamic Installation of Interference Bushings in CFRP

Polymer Composites, EarlyView.
Multiscale modeling for dynamic installatioin. ABSTRACT The dynamic installation of metal interference bushings has demonstrated significant potential for improving the mechanical performance of carbon fiber‐reinforced polymer (CFRP) joints. However, the underlying mechanisms governing the remaining life enhancement remain insufficiently understood ...
Yingjiang Guo, Zengqiang Cao, Dayou Ma, Lubin Huo, Andrea Manes   +4 more
wiley   +1 more source

Effect of cyclic hygrothermal aging on interlaminar fracture toughness of T700/TDE86 carbon composite

Journal of Aeronautical Materials, 2019
The artificial accelerated cyclic hygrothermal aging test was conducted on T700/TDE86 carbon fiber reinforced resin matrix composites, and the effects of different cyclic hygrothermal aging days on interlaminar fracture toughness of composites with open ...
XU Kailong, LIU Lulu, ZHAO Zhenhua, SHUANG Chao, CHEN Wei   +4 more
doaj   +1 more source

Experimental investigation on the hygrothermal behavior of a new multilayer building envelope integrating PCM with bio-based material

, 2021
Bio-based materials have strong hygrothermal behavior and phase change materials (PCMs) have high thermal inertia, but they have usually been studied separately in most research.
Dong-Xia Wu, M. Rahim, M. El Ganaoui, R. Djedjig, R. Bennacer, Bin Liu   +5 more
semanticscholar   +1 more source

Fiber‐Reinforced Bio‐Epoxy Composites: Degradation Mechanisms in Saline Environment

Polymer Composites, EarlyView.
Constituent level degradation of bio‐epoxy composites after saline aging. ABSTRACT This study examines the degradation behavior of bio‐epoxy composites reinforced with glass, basalt, carbon, and flax fiber yarns in a simulated saline environment. Fiber yarns and composite samples were exposed to 3.5% NaCl solution at 60°C for up to 3000 h.
Abdullah Iftikhar, Allan Manalo, Wahid Ferdous, Mazhar Peerzada, Hannah Seligmann, Kate Nguyen, Brahim Benmokrane   +6 more
wiley   +1 more source

Vibration characteristics of adhesive bonding repaired carbon fiber/epoxy laminate under hygrothermal condition

Journal of Aeronautical Materials, 2020
Through theoretical derivation and finite element simulation, the vibration characteristics of composite laminate with four-edge clamped support under hygrothermal condition were studied.
JIA Baohui, HAO Tongxing, ZHANG Gang, LU Xiang   +3 more
doaj   +1 more source

Predicting the hygrothermal behaviour of building components using neural networks [PDF]

MATEC Web of Conferences, 2019
Increasing the energy efficiency of the existing building stock can be accomplished by adding thermal insulation to the building envelope. In case of historic buildings with massive walls, internal insulation is often the only feasible post-insulation ...
Tijskens Astrid, Roels Staf, Janssen Hans   +2 more
doaj   +1 more source

Research on Self‐Identification Technology of Zero‐Value Insulators in Distribution Lines Based on Electroluminescence Effect

High Voltage, EarlyView.
ABSTRACT To address the issue of low detection accuracy for zero‐value insulators in distribution lines, this study proposes a novel method for detecting these insulators based on the electroluminescence effect. Through theoretical analysis and experimentation, it was found that the luminescence intensity of ZnS:Cu electroluminescent material varies ...
Jianghai Geng, Minghongtian Chen, Yunpeng Liu, Bo Peng, Yuming Zhang, Songsong Zhou, Ping Wang   +6 more
wiley   +1 more source

Strategizing IoT Platforms for Enhanced Hygrothermal Monitoring and Control in Libraries: A Transition from Passive to Proactive Operations

Preservation, Digital Technology & Culture
The management of book preservation, back volumes, and other publications within a library predominantly falls under the responsibility of library staff.
Sharath G. V. Krishna
doaj   +1 more source

Modeling Moisture Accumulation and Decay Potential in Cross-Laminated Timber Wall Assemblies Exposed During the Construction Phase

Buildings
This study examines decay risks in cross-laminated timber (CLT) wall assemblies with built-in moisture, aiming to develop a simulation-based methodology to assess moisture dynamics during the construction phase.
Anke Blommaert, Marijke Steeman, Nathan Van Den Bossche   +2 more
doaj   +1 more source

Surface engineering of recycled high‐density polyethylene‐based wood–polymer composites via carbon black‐containing surface film coating

Coloration Technology, EarlyView.
Abstract This study evaluates carbon black nanoparticle (CB NP)‐reinforced surface films for improving the durability, thermal stability, fire performance and mechanical retention of recycled high‐density polyethylene (HDPE)‐based wood‐plastic composites (WPCs) after 12 months of natural weathering.
Sefa Durmaz, Uğur Aras, İlkay Atar, Mehmet Acar, Özlem Özgenç Keleş, Özgün Vatansever, Erkan Avci   +6 more
wiley   +1 more source