Results 181 to 190 of about 15,343,575 (209)

Conformal Coating and Transfer of 2D Nanomaterials via Dynamic Interface Engineering

open access: yesAdvanced Materials Interfaces, EarlyView.
This review discusses conformal coating and transfer of two‐dimensional (2D) nanomaterials with a focus on dynamic interface engineering. By actively regulating nanosheet transport and interfacial contact during film formation, recent dynamic coating strategies overcome the limitations of conventional passive approaches and enable geometry‐adaptive ...
Seungyeon Kim   +4 more
wiley   +1 more source

Light‐Controlled Localized Delamination and Blistering of Azobenzene‐Containing Polymer Thin Films in an Aqueous Environment

open access: yesAdvanced Materials Interfaces, EarlyView.
When exposed to light of a defined wavelength, the photoisomerization of azobenzene chromophores leads to polymer reorientation, generating stresses that result in solvent‐facilitated localized delamination of the film from the substrate. Additionally, blisters that form spontaneously when exposed to an aqueous environment can be manipulated via ...
James Robert Benson   +4 more
wiley   +1 more source

Oxygen‐Controlled Structural and Defect Engineering of Magnetron‐Sputtered ZnO Thin Films for Photosensing

open access: yesAdvanced Materials Interfaces, EarlyView.
Zinc oxide thin films are engineered by controlling oxygen flow and nominal partial pressure during growth to tune atomic‐scale defects and crystallographic texture that limit device performance. By balancing competing defects, the films achieve improved preferential c‐axis orientation and enhanced ultraviolet photoresponse.
Julfikar Ali Sarkar   +2 more
wiley   +1 more source

Enhanced Xylene Sensing Performance of Fe‐Doped NiO Nanosheet Arrays via In Situ Growth

open access: yesAdvanced Materials Interfaces, EarlyView.
Xylene is a hazardous volatile organic compound (VOC) widely present in industrial environments, and achieving sensitive and stable detection of xylene remains a significant challenge for gas sensors. Here, a one‐step hydrothermal route was employed to in situ grow p‐type Fe‐doped NiO nanosheet arrays on ceramic tubes for xylene detection.
Yinglin Wang   +12 more
wiley   +1 more source

Coherent Carrier Transport at the Interface of Water‐in‐Salt and Organic Semiconductor Single Crystals

open access: yesAdvanced Materials Interfaces, EarlyView.
Water‐in‐salt electrolytes enable high‐density carrier accumulation and coherent transport at organic semiconductor single‐crystal interfaces. These aqueous interfaces offer a new platform for investigating high‐carrier‐density transport and developing device applications such as biosensing.
Pushi Wang   +6 more
wiley   +1 more source

Charge‐Trapping Multilayer Electrets for Partial Discharge Mitigated AlN Substrates

open access: yesAdvanced Materials Interfaces, EarlyView.
Multilayer electret films deposited on AlN substrates trap injected charge and generate an opposing electric field at the triple point. Finite‐element simulation shows the retained charge reduces the local field by about one third. Under steep high‐voltage pulses, the charged stacks raise the partial discharge inception voltage and lower the discharge ...
Md Nafis Washir   +2 more
wiley   +1 more source

Hybrid Roll‐To‐Plate Printed CMOS Logic Circuits Via an Integrated Gravure‐Flexographic Printing Strategy

open access: yesAdvanced Materials Interfaces, EarlyView.
A layer‐specific hybrid gravure–flexographic printing strategy enables fully printed SWCNT thin‐film transistors and CMOS logic circuits on flexible substrates. Flexographic printing forms the thin gate and drain‐source electrodes with defined edges, whereas gravure printing forms the uniform dielectric, semiconductor, and doping layers. The integrated
Junfeng Sun   +4 more
wiley   +1 more source

Enhanced CO2 Photoreduction by Lead‐Free Cs2AgBiBr6 Perovskites Coated With P3HT as Hole‐Extracting Polymer

open access: yesAdvanced Materials Interfaces, EarlyView.
P3HT‐coated Cs2AgBiBr6 perovskites are introduced as hybrid polymer–perovskite interfaces for CO2 photoreduction. The P3HT layer enhances interfacial hole extraction, suppresses charge recombination, and modulates product selectivity depending on the polymer coverage.
Andrea Di Vera   +4 more
wiley   +1 more source

Toward Perception‐Native Electronic Skin: Bio‐Inspired In‐/Near‐Sensor and Neuromorphic Computing for Humanoid Robots

open access: yesAdvanced Materials Technologies, EarlyView.
Dense tactile streams from across the humanoid body converge on collide in a central wiring and data bottleneck. By relocating computation closer to and then into the skin itself, near‐ and in‐sensor architectures, together with neuromorphic computing, chart a path toward perception‐native electronic skin, in which the conversion of stimulus into ...
Mijin Kim   +6 more
wiley   +1 more source
Some of the next articles are maybe not open access.

Related searches:

Polymer Semiconductors: Synthesis, Processing, and Applications

Chemical Reviews, 2023
Ze-Fan Yao, Yang Lu, Jie-Yu Wang
exaly  

Home - About - Disclaimer - Privacy