Results 121 to 130 of about 150,904 (241)
In the present paper, noise generation due to supersonic hot jet impingement (M=1.4 and Tt=950 K) to an inclined flat plate is experimentally investigated. In general, four types of acoustic waves are defined for jet impingement: acoustic waves generated
I. Bahman Jahromi +2 more
doaj
A piston bowl's design and spray angle improve air‐fuel mixing, resulting in more complete combustion and higher efficiency. Ansys Forte 2023 R1 a CFD software was used to analyze the effects of five combustion chamber geometries of cylinder, modified re‐entrant, re‐entrant, double‐stepped, and stepped on engine performance, combustion, and emission ...
Md. Nazmul Haque +7 more
wiley +1 more source
Glazed transpired solar collectors achieve 48–75% efficiency and 11% more seasonal heat than unglazed designs by cutting convective losses, while both offer complementary benefits for ventilation preheating and dynamic wall insulation, with paybacks of 5.5–6.8 years.
Mohammad Fawaier +7 more
wiley +1 more source
HYBRID-SYNTHETIC IMPINGING JETS
Impinging jets can achieve the highest convective heat or mass transfer rate. An increase beyond present limits is possible by pulsation of the flow. The extreme case of the synthetic jets could be particularly effective – were there not the re-ingestion
Tesař, Václav
core
This study on close coal seams shows that multi‐seam mining increases the height of the fractured zone from approximately 26 m (single upper‐seam mining) to about 49 m. When the lower seam is mined after the extraction of the upper seam, the heights of both the caved zone and the fractured zone increase by approximately two times.
Xiaoyu Wu +4 more
wiley +1 more source
Annular Jets and Annular Impinging Jets
A near field of annular jets and annular impinging jets is experimentally investigated at three inner/outer diameter ratios 0.84, 0.90 and 0.95. Time-mean velocity profiles are evaluated, and three main flow field zones are distinguished – in agreement ...
Turek, Tomáš
core
Turbulence intensity from 1% to 25% was parametrically tested on a three‐bladed H‐type Darrieus rotor across five tip speed ratios (TSRs) using two‐dimensional URANS. The optimal TSR proved the most efficient and most robust operating point simultaneously, with Cp losses capped at 5.8% even at TI = 25%. ABSTRACT The effect of inlet turbulence intensity
Aydin Ulus
wiley +1 more source
This review highlights recent advances in engineering messenger RNA (mRNA)‐lipid nanoparticles (LNPs) to cross the ageing blood–brain barrier and target neurodegenerative diseases. It outlines design principles, delivery routes, and translational challenges, charting a roadmap towards clinical application of mRNA‐LNP therapeutics for neurodegenerative ...
Abdel Ali Belaidi +5 more
wiley +1 more source
Simple and robust aqueous sheet jets in vacuum. [PDF]
Konold PE +40 more
europepmc +1 more source
Forced Draught Impact on Externally Venting Flames: An Experimental and Numerical Investigation
ABSTRACT Wind can significantly influence fire development and spread in urban and forest environments causing fatal consequences for the public, the first responders, and the environment. Wind‐driven fires can have a significant impact on structural fires as wind can increase the fire's intensity, development, and flame spread.
Anoop Subramania Warrier +5 more
wiley +1 more source

