Investigation of the Influence of Anti-Wear Coatings on the Surface Quality and Dimensional Accuracy during Finish Turning of the Inconel 718 Alloy. [PDF]
Materials (Basel), 2023 Smak K +4 more
europepmc +1 more source
Laser assisted turning of Inconel 718 alloy [PDF]
Mechanik, 2016 Tadeusz Chwalczuk +4 more
openaire +1 more source
Properties of cryogenically worked materials Interim report [PDF]
Cryogenically worked materials during strain ...
Brown, H. J. +3 more
core +1 more source
Application of integral damping for duct assembly vibration suppression Final report [PDF]
Bending mode vibratory response of supported and sleeved ducts with fatigue and alloy ...
Bowie, G. E., Compton, W. A.
core +1 more source
Effect of heat treatment and surface oxidation on low-cycle fatigue life of Inconel [PDF]
, 1970 Test program involving specimens with different heat treatment, surface condition, and chemical composition yields low cycle fatigue data on Inconel ...
Foster, S. D.
core +1 more source
Anomalies in the Geometric Surface Structure of Shaped Elements Composed of Inconel 718 Alloy. [PDF]
Materials (Basel), 2021 Krawczyk B +4 more
europepmc +1 more source
Metallurgy and properties of plasma spray formed materials [PDF]
Understanding the fundamental metallurgy of vacuum plasma spray formed materials is the key to enhancing and developing full material properties. Investigations have shown that the microstructure of plasma sprayed materials must evolve from a powder ...
Liaw, Y. K. +3 more
core +1 more source
, 2018 A microstructure-based model that accounts for the effect of grain size has been developed to study the effect of grain size on the fatigue life of Inconel 718 alloys.
Cruzado, A. +3 more
core +1 more source
Method of Data Selection for Turning of Inconel 718 Alloy Obtained by Casting and Laser Sintering Powder. [PDF]
Materials (Basel), 2022 Latosińska K +2 more
europepmc +1 more source
Influence of gaseous hydrogen on metals Interim report [PDF]
Gaseous hydrogen embrittlement in Inconel 718, Inconel 625, AISI 321 stainless steel, Ti-5Al-25Sn ELI, and OFHC ...
Chandler, W. T. +2 more
core +1 more source