Results 11 to 20 of about 28,439 (218)
World Electric Vehicle Journal, 2023 During wireless charging of the traction battery of electrically powered vehicles, the active area between the ground and vehicle assemblies must be monitored for inductive power transfer.
Uwe Hentschel +3 more
doaj +1 more source
Actuators, 2021 This work presents the results of the experimental and theoretical study of the static pull-in of tilting actuation executed by a hybrid levitation micro-actuator (HLMA) based on the combination of inductive levitation and electrostatic actuation. A semi-
Kirill Poletkin
doaj +1 more source
World Electric Vehicle Journal, 2022 If the energy transfer for charging the traction battery of an electric vehicle takes place wirelessly and with inductive components, the active area of the charging system must be monitored for safety reasons for the presence or intrusion of metallic ...
Uwe Hentschel +4 more
doaj +1 more source
Evaluation of Retained Austenite in Carburized Bearing Steel Using Magneto-Inductive Method
Crystals, 2023 The present work explores the magneto-inductive method to evaluate different levels of retained austenite content in carburized 20NiCrMo7 bearing steel while comparing the corresponding measurements by X-ray diffractometry and image analysis by optical ...
Laura G. Ionescu +5 more
doaj +1 more source
SiDIVS: Simple Detection of Inductive Vehicle Signatures with a Multiplex Resonant Sensor
Sensors, 2016 This work provides a system capable of obtaining simultaneous inductive signatures of vehicles traveling on a roadway with minimal cost. Based on Time-Division Multiplexing (TDM) with multiple oscillators, one for each inductive loop, the proposed system
José J. Lamas-Seco +3 more
doaj +1 more source
AIP Advances, 2019 There is a paucity of research on measurement of high rotational speed of direct-current motors using giant magneto-inductive sensors. In this work, measurements of high rotation-speed of brushed and brushless direct-current motors were realized by using
Tao Wang +3 more
doaj +1 more source
Micromachines, 2019 This paper reports the extraction of electrical impedance at microwave frequencies of vertically aligned multi-wall carbon nanotubes (VA MWCNT) bundles/forests grown on a silicon substrate.
Charlotte Tripon-Canseliet +5 more
doaj +1 more source
Predistortion for High-Speed Lumped Silicon Photonic Mach-Zehnder Modulators
IEEE Photonics Journal, 2022 The use of electrical precompensation for high-speed operation of lumped MZMs is demonstrated for 50 Gb/s PAM4 modulation through experiment and simulation.
Brian Murray +3 more
doaj +1 more source
Sensors, 2023 We demonstrate how resonant planar coils may be used as sensors to detect and quantify magnetic nanoparticles reliably. A coil’s resonant frequency depends on the adjacent materials’ magnetic permeability and electric permittivity.
José Luis Marqués-Fernández +5 more
doaj +1 more source
Frontiers in Nanotechnology, 2023 Magnetic nanoparticles (MNPs) are promising as local heat generators for magnetic hyperthermia under AC magnetic fields. The heating efficacy of MNPs is determined by the AC hysteresis loop area, which in turn is affected by the dynamic magnetic ...
Xuyiling Wang +3 more
doaj +1 more source