Results 21 to 30 of about 22,452 (291)
Novel immense configurations of boost converter for renewable energy application
The Journal of Engineering, 2019 A three-immense configurations of boost converter for renewable energy application is presented here. The voltage lift switched inductor (VLSI) structure is pledged to extra high-voltage conversion.
Pandav Kiran Maroti +4 more
doaj +1 more source
High step-up interleaved boost converter utilising stacked half-bridge rectifier configuration
The Journal of Engineering, 2019 This paper proposes a solution to complement the insufficient voltage gain and voltage stress distribution of classical interleaved boost converter in high step-up application.
Musbahu Muhammad +3 more
doaj +1 more source
DC–DC converter with a high step-down ratio for water desalination applications
The Journal of Engineering, 2019 A single-stage 600 : 1 ratio voltage step-down dc–dc converter designed to produce a voltage of between 1 and 1.5 V from a rectified single/three-phase AC supply, for application in a desalination process, is presented. A coupled-inductor design is used,
Richard C. Pollock +3 more
doaj +1 more source
Modeling and Measurements of Properties of Coupled Inductors
Energies, 2021 This paper proposes a model of a coupled inductor which takes into account the influence of frequency, temperature, and a constant component, IDC, of currents in the windings on the parameters of the considered element.
Kalina Detka +3 more
doaj +1 more source
Design of Pulse Spiral Inductor Wound by Rectangular Cross-Section Wire
IEEE AccessAccording to the structural characteristics of the spiral inductor wound by rectangular cross-section wire, a calculation model of pulse spiral inductor was established. A design method of pulse spiral inductor was presented, which takes inductance value,
Shuangpeng Hao +3 more
doaj +1 more source
MEMS inductor fabrication and emerging applications in power electronics and neurotechnologies
Microsystems & Nanoengineering, 2021 MEMS inductors are used in a wide range of applications in micro- and nanotechnology, including RF MEMS, sensors, power electronics, and Bio-MEMS.
Hoa Thanh Le +7 more
doaj +1 more source
Design of electromagnetic components for EV battery chargers
The Journal of Engineering, 2019 This study focuses on the appropriate design of the inductive elements of the LLC converter based on a typical industrial approach, i.e. assuming to use standard parts available on the market from qualified manufacturers.
Andrea Stratta +4 more
doaj +1 more source
Triple buck converter – an efficient low-distortion switch-mode power amplifier topology
The Journal of Engineering, 2019 A switch-mode power amplifier topology that can achieve both a high conversion efficiency and low-output signal distortion is introduced. Such systems are desirable for ultra-high precision amplifiers that, for example, drive actuators in nanometre ...
Mario Mauerer +2 more
doaj +1 more source
Diversity and complexity in neural organoids
FEBS Letters, EarlyView.Neural organoid research aims to expand genetic diversity on one side and increase tissue complexity on the other. Chimeroids integrate multiple donor genomes within single organoids. Self‐organising multi‐identity organoids, exogenous cell seeding, or enforced assembly of region‐specific organoids contribute to tissue complexity.
Ilaria Chiaradia, Madeline A. Lancaster
wiley +1 more source
International Journal of Photoenergy, 2013 In three-phase photovoltaic (PV) system, three-phase filter inductors are important part for the output electrical power quality. The comparison analyses of three-phase discrete filter inductors and two kinds of three-phase integrated filter inductors in
Ying Jiang +5 more
doaj +1 more source