Results 41 to 50 of about 36,427 (314)
Arthritis Care &Research, EarlyView.Objective The aim of this study was to determine the differences in demographic, serologic, and clinical characteristics between male and female patients with systemic sclerosis (SSc) in an Australian cohort. Methods This was a retrospective observational study using data from the Australian Scleroderma Cohort Study.
Emily Lin +14 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
MetalsThe internal recycling of iron-rich fine residues is a crucial process for reducing the raw material loss and the carbon footprint in sustainable ironmaking and steelmaking.
Lars Hans Gronen +7 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study presents a reversible temperature sensor with high switching ratio, ∼103. The device is fabricated using PET‐ITO and carbon nanotube dispersions in alkane. Considering its application in cold chain logistics, a proof‐of‐concept with LED is showcased. Thus, a temperature drop below the threshold temperature (crystallization temperature of the
Sunil Kumar Behera +8 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Balancing the Energy Efficiency Benefits of Glazed Surfaces: A Case Study
BuildingsDaylighting design is not only dimensioning glazed surfaces to provide sufficient natural light to an occupied space but also a method of analyzing how this can be achieved without unwanted effects, such as gains and losses of heat, glare, and variations
Dorina-Nicolina Isopescu +6 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study explored how effective nickel aluminide coatings are obtained in providing oxidation resistance applied to the Inconel 738 alloy, modeling with diffusion models. In the present study, kinetics and thermal behavior of the Inconel 738 alloy were studied by the low‐temperature thermoreactive aluminizing process, which was carried out at 625°C ...
Gozde Celebi Efe +4 more
wiley +1 more source
AERODYNAMICS OF INDUSTRIAL BUILDINGS
Zernovì Produkti ì KombìkormaThe design of metal silos and other structures (towers, silo galleries) of the grain receiving point under the influence of wind load is considered in the work.
V. Petrov, D. Gоncharenko, O. Zhdanov
doaj +1 more source
Buildings, 2019 Used properly, daylight can provide visual comfort, reduce energy consumption and improve health and safety at work. This paper investigates the influence that different roof types, (i.e., sawtooth roof, skylight and monitor), have on daylight levels ...
Theodora Mavridou, Lambros T. Doulos
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source