Results 21 to 30 of about 22,614 (219)
Composites Part C: Open Access, 2021 In this paper tribo-comparison of two SLs viz. graphite and PTFE as a secondary lubricant in composites with identical composition (20 wt%) is presented.
Jitendra Narayan Panda +2 more
doaj +1 more source
Lubrication of DLC Coatings with Two Tris(pentafluoroethyl)trifluorophosphate Anion-Based Ionic Liquids [PDF]
, 2013 The lubrication of a Cr-DLC coating with ethyl-dimethyl-2-methoxyethylammonium tris(pentafluoroethyl)trifluoropho-sphate [(NEMM)MOE][FAP] and 1-butyl-1-methylpyrro-lidinium tris(pentafluoroethyl)trifluorophosphate [BMP] [FAP] ionic liquids (ILs) as 1 wt%
A. Fernández-González +5 more
core +1 more source
Crystals, 2018 Thermally reduced graphene oxide (TRGO) was incorporated as a reinforcing filler in the epoxy resin to investigate the effect on the mechanical properties of carbon fiber (CF)/epoxy composites.
Nitai Chandra Adak +4 more
doaj +1 more source
Industrial Tribology in Korea: Past, Present and Near Future
Tribology Online, 2007 In the past three decades Korea has developed into a highly industrial nation, recording an annual growth rate of more than 8 percent. The rapid growth in Korean economy was possible through technological developments and innovations that spread across a
Dae-Eun Kim
doaj +1 more source
Influence of MHD Lubrication and Textured Surface in EHL Line Contact
Frontiers in Mechanical Engineering, 2019 The present numerical study investigates the combined effect of micro-texture and magneto hydrodynamic lubrication behavior on the performance of elastohydrodynamic lubrication (EHL) line contact.
Suresh Jadhav +2 more
doaj +1 more source
Chinese Journal of Mechanical Engineering, 2020 Oil leakage between the slipper and swash plate of an axial piston pump has a significant effect on the efficiency of the pump. Therefore, it is extremely important that any leakage can be predicted.
Özkan Özmen +3 more
doaj +1 more source
ITC Tokyo 2015 Special Issue,Papers from International Tribology Conference, Tokyo 2015 (Part 1)-
Tribology Online, 2016 The 7th International Tribology Conference, Tokyo 2015, was held on 16–20 September 2015 at Katsushika Campus of Tokyo University of Science, located at the east end of Tokyo Metropolitan, Japan.At the ITC Tokyo 2015, over 600 registered ...
Shigeka Yoshimoto
doaj +1 more source
Energy efficiency measurement procedure for gearboxes in their entire operating range [PDF]
, 2014 Over the last decade, forced regulations and a growing social awareness with respect to energy efficiency have resulted in a renewed interest in the research for high efficient electrical machines.
Algoet, Elewijn +5 more
core +1 more source
Results in Engineering, 2023 High level of noise limits the reliability of the lubricated journal bearing. In the current paper, the possibility of bearing design with a heterogeneous rough/smooth surface is explored using the computational fluid dynamics (CFD) approach to improve ...
Mohammad Tauviqirrahman +5 more
doaj +1 more source
Material Characterization and Real-Time Wear Evaluation of Pistons and Cylinder Liners of the Tiger 131 Military Tank [PDF]
, 2013 Material characterisation and wear evaluation of the original and replacement pistons and cylinder-liners of Tiger 131 is reported. Original piston and cylinder-liner were operative in the Tigers’ engine during WWII.
Adil Saeed +8 more
core +1 more source