Results 21 to 30 of about 975,679 (231)
Journal of Asian Architecture and Building Engineering, 2023 The steel frame infilled with the autoclaved lightweight aerated concrete (AAC) masonry wall is widely applied in buildings. However, earthquake damage investigation has revealed that infill walls have a significant influence on the mechanical behaviors ...
You-Sheng Yu +3 more
doaj +1 more source
Frontiers in Built Environment, 2023 Introduction: Seismic damage affecting the non-structural components of buildings (such as infills) can significantly impact the expected economic losses over a structure’s service life.
Marco Giulivo +3 more
doaj +1 more source
Numerical Analysis of Infill Plate Performance on Steel Plate Shear Wall (SPSW) [PDF]
, 2023 Steel Plate Shear Wall (SPSW) is one of the systems that can be used to minimize the effect of earthquakes on buildings. The main energy-absorbing element of the steel plate shear wall system is on the thin steel plate that are located on the center of ...
Muslikh, Muslikh +3 more
core +1 more source
Influence of Rectilinear Infill Parameters on Stress State of Mechanical Structures Components [PDF]
Robotica & Management, 2020 The use of additive manufacturing to produce mechanical components with internal infill lattice leads to material savings, decrease of weight and decrease of inertial loads.
Vasile Cojocaru +1 more
doaj
Numerical Study on Seismic Behavior of Moment-Resistant Steel Frames with Hybrid Masonry Infill [PDF]
Journal of Structural and Construction Engineering, 2020 Hybrid masonry system is a new structural system, in which the masonry panels link to the frame with steel plate connections. Hybrid masonry uses masonry infill for lateral stiffness and strength within frames in addition to supporting out-of-plane ...
Mahmoud Reza ُُShiravand +1 more
doaj +1 more source
Engineered Cementitious Composites Effects on Seismic Strengthening of Non-ductile RC frames with masonry infills [PDF]
مهندسی عمران شریف, 2021 Performance of fiber reinforced Engineered Cementitious Composites (ECC) strengthened by non-ductile Reinforced Concrete (RC) frames with hollow clay brick masonry infill subjected to quasi-static in-plane loading was experimentally assessed herein.
M.K. Sharbatdar, A.R Tajari
doaj +1 more source
Comparison of Analytical Methods for Modelling Masonary Infill by Considering In-Plane and Out-of-Plane Interaction [PDF]
Journal of Structural and Construction Engineering, 2021 Masonry infilled reinforced concrete frame buildings built prior to the introduction of modern seismic provisions have been observed to undergo damage in and around the masonry infill walls during most recent moderate to severe earthquakes.
Delaram Ostad, Jalil Shafaei
doaj +1 more source
Geosciences, 2023 Discontinuities mainly control the mechanical behavior of rock mass and cause a significant reduction in the rock mass strength. Joint persistency and joint infill conditions are considered the most significant joint parameters that control the ...
Mariam Al-E’Bayat +2 more
doaj +1 more source
Numerical Evaluation of the Behavior of Steel Frames with Gypsum Board Infill Walls
Advances in Civil Engineering, 2019 In this paper, the behavior of steel frames with gypsum board infill walls is studied through finite element simulation. For this purpose, a typical steel frame with infill wall which had been previously tested is considered as a benchmark model.
Mehrdad Movahednia +2 more
doaj +1 more source
Steel Plate Shear Wall with Different Infill Steel Plates [PDF]
Computational Engineering and Physical Modeling, 2018 The steel plate shear wall (SPSW) system is one of the most common and acceptable lateral-resisting structural systems for steel structures. Although the advantages of SPSW over the other structural systems are somehow well-known, the wall-farm ...
Mohammad Hossein Kashefizadeh +3 more
doaj +1 more source