Results 111 to 120 of about 462,529 (288)

Interaction between Molten Al‐Killed Mn–B Steel and Carbon‐Bonded MgO Refractories Based on Recyclates

Advanced Engineering Materials, EarlyView.
High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé, Lukas Neubert, Anton Yehorov, Till M. J. Stadtmüller, Christos G. Aneziris, Olena Volkova   +5 more
wiley   +1 more source

Bibliometric Analysis of the Application of Soil Amendments in Improving Soil Infiltration and Storage Capacity over the Last 20 Years

Agriculture
The infiltration and water-holding properties of soil are essential for the efficient utilization of farmland water and the control of soil erosion. Soil amendments can enhance soil infiltration and storage capacity by increasing the cohesion between ...
Xiaolan Ju, Xihuan Sun, Lijian Zheng, Juanjuan Ma   +3 more
doaj   +1 more source

Estimation of Infiltration Curved Formulas by using Infiltration Capacity Experiment in the Hongcheun-River Watershed

Journal of korean society of hazard mitigation, 2012
This study provided the value of infiltration capacity by soils after taking experiments of initial infiltration capacity on 29 sites from 18 soil series that were selected from the area of Hongcheon River. According to the result of our study, there is no significant difference between the field and the paddy in terms of initial infiltration capacity,
Young Bok Kang, Bong Jin Kim, Soo Jin Park, Han Kuy Choi   +3 more
openaire   +1 more source

The impact of grazing cattle on soil physical properties and nutrient concentrations in overland flow from pasture, Part B [PDF]

, 2007
This report has been prepared as part of the Environmental Research Technological Development and Innovation Programme 2000–2006. The programme is financed by the Irish Government under the National Development Plan 2000–2006.End of project reportThe ...
Bourke, David, Kurz, Isabelle, O’Reilly, Conor, Tunney, Hubert   +3 more
core  

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti, Finn‐Lennard Janthur, Selina Raumel, Sascha Jan Zimmermann, Sarah Seffer, René Gustus, Sebastian Herbst, Marc C. Wurz, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Florian Nürnberger   +11 more
wiley   +1 more source

Piezoresistive Monitoring of Carbon Nanomaterial‐Reinforced Epoxy Composites Under Cyclic and Fatigue Loading: A Review

Advanced Engineering Materials, EarlyView.
Carbon nanomaterial‐reinforced epoxy composites exhibit pronounced piezoresistive behavior, enabling intrinsic damage sensing under cyclic and fatigue loading. This review critically compares carbon nanotube and graphene systems, correlating filler content, percolation threshold, and gauge factor with sensing stability and damage evolution.
J. M. Parente, J. Nunes‐Pereira, A. P. Silva, P. N. B. Reis   +3 more
wiley   +1 more source

Estimation of field capacity from ring infiltrometer-drainage data [PDF]

Revista Brasileira de Ciência do Solo, 2014
Field capacity (FC) is a parameter widely used in applied soil science. However, its in situ method of determination may be difficult to apply, generally because of the need of large supplies of water at the test sites. Ottoni Filho et al.
Theophilo Benedicto Ottoni Filho, Marta Vasconcelos Ottoni, Muriel Batista de Oliveira, José Ronaldo de Macedo   +3 more
doaj   +1 more source

????????? ??????????????? ?????? ??????????????? ?????? ??????????????? [PDF]

, 2018
Department of Energy Engineering (Battery Science and Technology)The continuous throng in demand for high energy density rechargeable batteries innovatively drives technological development in cell design as well as electrochemically active materials. In
Jeong, Dae-Hyeon
core  

3D‐Printed Giant Magnetoresistive (GMR) Sensors Based on Self Compliant Springs

Advanced Engineering Materials, EarlyView.
This work explores 3D‐printed GMR sensors utilizing self‐compliant spring structures and conductive PLA composites. By optimizing arm width, we achieved high piezoresistive (0.34%/mm) and magnetoresistive (0.77%/mT) sensitivities. Demonstrated through Bluetooth‐integrated pressure and magnetic position sensing, these full printed low‐cost, customizable
Josu Fernández Maestu, Nelson Pereira, Javier Vicente, Carmen Rial Tubio, Senentxu Lanceros‐Méndez   +4 more
wiley   +1 more source

Spatial Approach to Infiltration and Groundwater Level: Implications For Sustainable Settlement Planning

Jurnal Pembangunan dan Alam Lestari
Rapid land use change due to population growth and urbanization presents significant challenges to urban development. This study aims to map the groundwater level and water infiltration conditions in residential areas and investigate the conditions in ...
Trisno Widodo, Antariksa Antariksa, Fadillah Putra, Septiana Hariyani   +3 more
doaj   +1 more source