Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Diagnosis of Distribution Function in Inherent Strain Method
Preprints of the National Meeting of JWS, 2007 nakacho, keiji +2 more
openaire +1 more source
Advanced Engineering Materials, EarlyView.This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
Assessing Altered Coating Adhesion on Plasma‐Deoxidized Surfaces Under Oxygen‐Free Conditions
Advanced Engineering Materials, EarlyView.This study demonstrates the effectiveness of atmospheric pressure plasma pretreatment in modifying silicon and stainless steel surfaces to improve adhesion. Argon‐hydrogen plasma increases surface roughness and improves adhesion strength, whereas pure argon results in smoother surfaces and structural changes.
Selina Raumel +6 more
wiley +1 more source
A new variant of the inherent strain method for the prediction of distortion in powder bed fusion additive manufacturing processes. [PDF]
Int J Adv Manuf TechnolPourabdollah P +3 more
europepmc +1 more source
Analysis of Stress Intensity Factor due to Surface Crack Propagation by Using Influence Function Method and Inherent Strain Analysis in Residual Stress Fields Caused by Welding [PDF]
Stress intensity factor due to surface crack propagation was analyzed by using the Influence function method and inherent strain analysis of residual stress fields caused by welding.
Kanno, Satoshi +13 more
core
Evaluating Energy Absorption Performance of Filled Lattice Structures
Advanced Engineering Materials, EarlyView.Maximum stress must be considered to robustly evaluate energy absorber designs. This approach was applied to compare all types of absorbers in a single Ashby diagram and determine the utility of filling lattice voids with a second material. High‐performance fillers can improve the performance of lattices that are limited by buckling or catastrophic ...
Christian Bonney +2 more
wiley +1 more source
Effect of Welding Gap of Thin Plate Butt Welds on Inherent Strain and Welding Deformation of a Large Complex Box Structure. [PDF]
Materials (Basel)Zhang L +7 more
europepmc +1 more source
Analysis of the Shaft Resistance of Nondisplacement Piles in Sand
, 2008 The paper examines, using numerical modelling, the problem of the limit shaft resistance of non-displacement piles installed in sands. The modelling makes use of an advanced, two-surface-plasticity constitutive model.
Loukidis, D, Salgado, Rodrigo
core