Results 1 to 10 of about 649,934 (254)
Diagnosing injection-production system faults in the same well using the rough set-LVQ neural network. [PDF]
This study proposed a reverse calculation model of the unique rod pump injection and production system structures in the same well to diagnose and resolve defects, after which dynamometer diagrams of the system production and injection pumps were drawn ...
Yi Fang Yin +3 more
doaj +5 more sources
Water cut analysis and optimization of injection–production​ system for densifying well network
Based on the historical information and production status of the oil field, the production situation and the main contradictions that exist at present are analyzed. In response to the problems of the low number of water wells and imperfect injection and recovery well types after block encryption adjustment, this paper proposes two adjustment schemes ...
Xiaoju Yin +4 more
openaire +4 more sources
Feasibility study on adjustment of injection-production system in extremely high water cut period [PDF]
Entering the stage of ultra-high water cut development, affected by faults and irregular well patterns in some areas, there are problems in the development of oilfields such as imperfect injection-production systems, high oil-water wells ratio, low multi-
Cao Guoqiang
doaj +2 more sources
Calculation on a reasonable production/injection well ratio in waterflooding oilfields
According to the accurate definition of the reasonable production/injection well ratio and injection/production ratio for waterflooding oilfields, the formula of the reasonable production/injection well ratio under the same or different formation ...
Cunyou Zou +3 more
doaj +3 more sources
This paper proposed a method of injection-production system adjustment to solve the problem that the water flooding effect was restricted because of the horizontal and vertical contradictions during the development process of fault block reservoirs. Considering the heterogeneity of reservoir, the Buckley-Leverett water flooding theory was applied to ...
Ming Yang +4 more
openaire +4 more sources
Based on the independently developed true triaxial multi-physical field large-scale physical simulation system of in-situ injection and production, we conducted physical simulation of long-term multi-well injection and production in the hot dry rocks of ...
Peng ZHAO +6 more
doaj +3 more sources
Analysis of factors affecting water injection effect of single sand body and research on control measures [PDF]
According to the isotopic data annular monitoring, test results, well group control degree and other data, the water absorption status trend map of single sand body is manually drawn by using the oil well sealing method and the equal interval data ...
Han Fei
doaj +1 more source
Discussion on the Optimization of Injection and Production Parameters in the Western Fault Zone of T Zone [PDF]
This article mainly applies the injection-production balance board, combining the dynamic experience of oilfield development to optimize the adjustment method of injection and production parameters in fault area.
Lou shengrui
doaj +1 more source
How to improve the heat extraction performance of HDR (hot dry rock) is one of the most concerned problems in HDR extraction. The key is to take a reasonable method to evaluate the heat extraction performance of hot dry rock and find out the main factors
Kai Zhao +6 more
doaj +1 more source
Design and productivity evaluation of multi-lateral well enhanced geothermal development system
Enhanced geothermal development system is an effective means to develop hot dry rock geothermal resources, and its reasonable structural design is crucial to the efficient exploitation of hot dry rocks.
Jie Zhang, Jingxuan Xie
doaj +1 more source

