Results 11 to 20 of about 2,485,273 (247)
Powder co-injection moulding [PDF]
, 2000 A novel powder processing technique has been developed by combining conventional powder injection moulding with polymer co-injection moulding, to permit the in-situ surface engineering of metal or ceramic components as an integral step within the ...
Hanson, S. M. J.
core +7 more sources
Large Section Ceramic Injection Moulding [PDF]
, 2000 PhDCeramic injection moulding is already established as a production technique for complex shaped ceramic components. However the process is limited to thin section mouldings generally not exceeding a wall thickness of 10 mm.
Krug, S., Krug, Steffen
core +4 more sources
MOVPE-Grown Quantum Cascade Laser Structures Studied by Kelvin Probe Force Microscopy
Crystals, 2020 A technique for direct study of the distribution of the applied voltage within a quantum cascade laser (QCL) has been developed. The detailed profile of the potential in the laser claddings and laser core region has been obtained by gradient scanning ...
Konstantin Ladutenko +3 more
doaj +1 more source
Study on Premixed Combustion in a Diesel Engine with Ultra-multihole Nozzle
Journal of Combustion, 2011 This study proposed a new low-temperature premixed combustion mode to achieve the simultaneous reduction of NOx and soot emissions in a volume production diesel engine of CA6DF by reconstructing key systems. Some developments of this diesel engine are as
Xuelong Miao +7 more
doaj +1 more source
Experimental assessment of the gray cast iron production by inoculant injection [PDF]
Journal of Mining and Metallurgy. Section B: Metallurgy, 2021 An initial assessment of the gray cast irons production by injecting an inoculant with a conveying gas into a molten iron bath was evaluated at a laboratory scale.
Reyes-Castellanos G. +5 more
doaj +1 more source
Performance Comparison of the Vapor-Injection Cycle in Terms of Branching Points of the Injection Stream [PDF]
, 2012 The performance of the two types of vapor-injection (VI) cycles in a heat pump system is compared. The vapor-injection cycle using an internal heat exchanger (IHX) has a choice to select the branching point of the injection stream.
Kim, Min Soo, Roh, Chul Woo
core +1 more source
Long wavelength VCSEL-by-VCSEL optical injection-Locking [PDF]
, 2009 VCSEL-by-VCSEL optical injection-locking to obtain high cut-off frequencies of 1.3 μm Vertical-Cavity Surface-Emitting Lasers (VCSELs) is demonstrated. A detailed physical explanation of the underlying mechanism is presented.
Sirbu, A. +13 more
core +1 more source
A Fault Injection Environment for Microprocessor-based Board [PDF]
, 1998 Evaluating the faulty behaviour of low-cost microprocessor-based boards is an increasingly important issue, due to their usage in many safety critical systems. To address this issue, the paper describes a software-implemented fault injection system based
Rebaudengo, Maurizio +3 more
core +1 more source
Current materials and techniques in cosmetic hand injections
Journal of Plastic Surgery and Hand SurgeryBackground: With the widespread popularity and development of aesthetic treatments, the focus has extended from facial aging to include the aging of hands.
Yutong Liang +5 more
doaj +1 more source
Fault Injection for Embedded Microprocessor-based Systems [PDF]
, 1999 Microprocessor-based embedded systems are increasingly used to control safety-critical systems (e.g., air and railway traffic control, nuclear plant control, aircraft and car control).
Rebaudengo,Maurizio +6 more
core +1 more source