Results 201 to 210 of about 34,137 (304)

Development and Validation of a 1D Dynamic Model of an Injection Moulding Process and Design of a Model-Based Nozzle Pressure Controller. [PDF]

Polymers (Basel)
Hertz RA, Therkelsen O, Kristiansen S, Christensen JK, Hansson FA, Schmidt L.   +5 more
europepmc   +1 more source

Investigation of a Short Carbon Fibre-Reinforced Polyamide and Comparison of Two Manufacturing Processes: Fused Deposition Modelling (FDM) and Polymer Injection Moulding (PIM). [PDF]

Materials (Basel), 2020
Verdejo de Toro E, Coello Sobrino J, Martínez Martínez A, Miguel Eguía V, Ayllón Pérez J.   +4 more
europepmc   +1 more source

Rheology of injection in injection moulding

Metal Powder Report, 1999
openaire   +1 more source

A Soft Robotic Device for Targeted Massage Therapy of Residual Limbs

Advanced Robotics Research, EarlyView.
Residual limb edema after amputation can hinder recovery and delay prosthetic fitting. This study presents a soft‐robotic wearable device that delivers sequential compression through pneumatic McKibben actuators. By replicating the principles of manual lymphatic drainage, the device generates controlled mechanotherapeutic pressure patterns, providing a
Maria Grazia Polizzotto, Alessio Capecchi, Maartje Van der Lingen, Emanuele Gruppioni, Arianna Menciassi, Linda Paternò   +5 more
wiley   +1 more source

Debinding of Yttria-Stabilised Zirconia/Bimodal Stainless Steel 316L Bi-Materials Produced through Two-Component Micro-Powder Injection Moulding. [PDF]

Polymers (Basel)
Basir A, Sulong AB, Muhamad N, Juri AZ, Jamadon NH, Foudzi FM, Radzuan NAM.   +6 more
europepmc   +1 more source

3D‐Printing Aided Rapid Prototyping of Pretensioned Tensegrity Structures for Robotic Applications

Advanced Robotics Research, EarlyView.
Printing, injection molding, and assembly (PMA) is a method for rapid prototyping mesoscale, topologically complex, and tensioned tensegrity structures. In combination with PMA method, two mold design strategies: modular mold and compact channel layout, enable efficiency and scalability for tensegrity fabrication.
Yi Sun, Jan Petrš, Omar Aloui, Dario Floreano   +3 more
wiley   +1 more source

Injection moulding simulation of mould filling

Metal Powder Report, 2000
openaire   +1 more source

Magnetic Micro‐ and Nanorobots for Precision Thrombolysis: Design Strategies and Translational Challenges

Advanced Robotics Research, EarlyView.
Micro‐ and nanorobots for targeted thrombolysis. This perspective elaborates on the clinical indication of blood clot disorders and current limitations for treatment. As a novel, alternative solution, micro‐ and nanorobots can be used to treat and break down thrombi.
Joshua M. Mesfin, Yimo Yan, Nikola Cesarovic, Simone Schuerle   +3 more
wiley   +1 more source

Simulation of mould cooling in injection moulding

Metal Powder Report, 1991
openaire   +1 more source

Micro injection moulding and multi component micro injection moulding

, 2012
Piotter, V., Honza, E., Klein, A., Müller, T., Plewa, K.   +4 more
openaire   +3 more sources