Effect of liquid level monitor gas injection point size on information source amplitude-frequency characteristics [PDF]
Scientific ReportsIn order to analyse the effect of the injection point size of the CBM (Coalbed Methane) well level monitor on the amplitude and frequency of pressure pulsations in the wellhead manifold, numerical simulations and experiments were carried out to ...
Pu Liu +4 more
doaj +2 more sources
Three Dimensions of Precision in LetibotulinumtoxinA Treatment: Dose, Dilution and Injection Pattern in Relation to Diffusion [PDF]
ToxinsBotulinum neurotoxin type A (BoNTA) is widely used for the treatment of dynamic facial wrinkles, where precise control of toxin diffusion is essential to achieve predictable aesthetic outcomes while preserving natural facial expression.
Maxine Bennek, Martina Kerscher
doaj +2 more sources
Local anaesthetic injection point of erector spinae plane block [PDF]
Indian Journal of Anaesthesia, 2018 Serkan Tulgar, Onur Balaban
doaj +2 more sources
Point-to-plane and plane-to-plane electrostatic charge injection atomization for insulating liquids.
, 2010 Point-to-plane and plane-to-plane electrostatic charge injection atomization for insulating ...
Ghazi. Malkawi (7985222)
core +4 more sources
Indian Journal of Anaesthesia, 2023 Background and Aims: Sciatic nerve block at the popliteal level for lower limb procedures provides unpredictable success rates even with ultrasonographic (USG) guidance.
Kush Nag +3 more
doaj +1 more source
A Study of Injection Moulding with Bismuth Alloy [PDF]
, 2013 There is a demand to produce parts in small quantities, using cost effective injection moulding processes. The emerging economic case suggests there will be advantages in producing injection moulding tools for short duration low volume production runs ...
Unver, Ertu +6 more
core +3 more sources
Powder co-injection moulding [PDF]
, 2000 A novel powder processing technique has been developed by combining conventional powder injection moulding with polymer co-injection moulding, to permit the in-situ surface engineering of metal or ceramic components as an integral step within the ...
Hanson, S. M. J.
core +4 more sources
Diesel injector dynamic modelling and estimation of injection parameters from impact response Part 1: modelling and analysis of injector impacts [PDF]
, 1996 Part 1 of this paper presents the development and validation of a detailed dynamic model for the needle motion of a common hole‐type diesel fuel injector as used in a direct injection diesel engine.
Gu, Fengshou, Ball, Andrew
core +1 more source
Indonesian Journal of Obstetrics and Gynecology, 2012 Objective: To compare the score of VAS (visual analog scale), length of labor, and APGAR score in intracutaneous sterile water injection between one point technique and four points technique at Michaelis Rhomboid area in management of labor pain. Method:
Taufik Ismail
doaj +1 more source
Diesel engine fuel injection monitoring using acoustic measurements and independent component analysis [PDF]
, 2010 Air-borne acoustic based condition monitoring is a promising technique because of its intrusive nature and the rich information contained within the acoustic signals including all sources.
Gu, Fengshou +7 more
core +1 more source