Results 211 to 220 of about 843,286 (262)

Thermoporoelastic flow control strategies for enhancing the longevity of hydraulic fracture-based enhanced geothermal systems

Tangirala SK, Kivi IR, Vilarrasa V.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Injection Profiling Through Temperature Warmback Analysis Under Variable Injection Rate and Variable Injection Temperature

Transport in Porous Media, 2021
Mehdi Zeidouni
exaly   +2 more sources

TEMPERATURE LOGGING IN INJECTION WELLS

Proceedings of Fall Meeting of the Society of Petroleum Engineers of AIME, 1972
This paper was prepared for presentation at the 47th Annual Fall Meeting of the Society of Petroleum Engineers held in San Antonio, Tex., Oct. 8–11, 1972. Permission to copy is restricted to an abstract of not more than 300 words. Illustrations may not be copied.
E.J. Witterholt, M.R. Tixier
openaire   +1 more source

Pain on injection of propofol: the effect of injectate temperature

Anaesthesia, 1990
Summary A double‐blind, randomised clinical study was undertaken to compare the effect of temperature on the incidence and severity of the pain experienced on injection of propofol. The number of patients who experienced pain and the severity of the pain were reduced significantly when propofol was administered at a temperature of 4°C.
A, McCrirrick, S, Hunter
openaire   +2 more sources

Injection moulding of thermosets. Effect of the temperature of injection

European Polymer Journal, 1993
Abstract In order to reduce the cycle time of cure of thermosets, one of the best method is to use a system of injection moulding. This system enables one to inject the thermoset at a higher temperature than room temperature in the heated mould. Thus the heating period of the resin may be significantly reduced.
H. Hadi, K. Azaar, A. El Brouzi, R. Granger, J.M. Vergnaud   +4 more
openaire   +1 more source

The Effect of Avgas Fuel Injection Pressure on Injection Temperature

International Journal of Emerging Trends in Engineering Research, 2023
The use of internal combustion engines has become common in transportation, especially in aviation, one of which is the Cessna training aircraft with a piston engine. The effect of fuel injection pressure on injection temperature has been a focus of many studies because it has the potential to improve combustion efficiency.
openaire   +1 more source

Impacts of injection temperature on the CO2 injection capacity in the different sloping formations

Environmental Science and Pollution Research, 2020
The CO2 injection capacity directly affects the CO2 storage efficiency. Injection temperature and formation sloping degree affect the CO2 injection capacity. Based on the actual geological conditions of the Shiqianfeng Formation in the Ordos Basin of China, a three-dimensional (3D) simulation model was established to evaluate pressure, temperature, CO2
Jing, Jing, Wei, Zhou, Yanlin, Yang, Lin, Zuo, Zhonghua, Tang   +4 more
openaire   +2 more sources

No‐flow temperature in injection molding simulation

Journal of Applied Polymer Science, 2010
AbstractMost injection molding simulation packages use the no‐flow temperature (NFT) as a means of determining whether the polymer flows or is solid. The NFT is not well defined, and a standard method for measuring it does not exist. A sensitivity analysis of the filling stage has been carried out with two different packages [VISI Flow (Vero Software ...
MANNELLA, Gianluca Antonio, LA CARRUBBA, Vincenzo, BRUCATO, Valerio Maria Bartolo, Zoetelief, W, Haagh, G.   +4 more
openaire   +2 more sources