Results 1 to 10 of about 4,869,594 (291)
Geometry Optimization of a Gas Preheater Inlet Region – A Case Study
Measures for the improvement of process waste gas (PWG) distribution into U-tubes of a tube bank heat exchanger, which is a part of a liquid and gaseous wastes incineration unit, are discussed.
V. Turek, P. Belohradský, Z. Jegla
doaj +2 more sources
Effect of Re-burn Fuel Stream Location on NO Reduction in a Model Pulverized Coal Combustor [PDF]
I is missing this work, a computational simulation has been performed to investigate the positional effect of reburn fuel injection on NO-reburn.
Ajay Kumar Sahu, Prakash Ghose
doaj +1 more source
Large Methane Emission from the River Inlet Region of Eutrophic Lake: A Case Study of Lake Taihu
Lakes are important natural sources of atmospheric methane (CH4), which should be considered in global CH4 budget estimations. However, the CH4 emissions from lakes can be highly variable, and the emissions from the river inlet region were less studied ...
Yuanshan Liao +7 more
doaj +1 more source
The Effect of Regional Winds on Subtidal Along‐Inlet Currents at Oregon Inlet, NC
AbstractWind influence on tidal inlet hydrodynamics is examined using 40 days of wind, water level, and current observations collected in Spring 2019 at Oregon Inlet, NC, a large (1 km wide, 1–13 m deep) meso‐tidal inlet with complex delta systems. Wind velocities through the inlet (ranging 0–18 m/s) are modulated at subtidal timescales and are well ...
J. L. Humberston, T. C. Lippmann
openaire +1 more source
Oil film inlet temperature model for directed lubrication tilting pad journal bearing
Directed lubrication tilting pad journal bearings are used for high peripheral speed conditions. In the bearing, oil is supplied between pads and it mixes outlet oil from an upstream pad at oil inlet region.
Tomoaki YAMASHITA +2 more
doaj +1 more source
Developing heat transfer in a tube subjected to a constant heat flux is investigated in the case of simultaneously developing fluid flow of a power law fluid in a circular duct using an integral boundary layer model.
Muhammad Faheem Hassan, Rachid Chebbi
doaj +1 more source
The laminar-turbulent transition of a boundary layer induced by a jet injection in the inlet region of a circular pipe was experimentally investigated.
Masashi ICHIMIYA +2 more
doaj +1 more source
The complexity or randomness of the laminar-turbulent transition process of an inlet boundary layer in a circular pipe was analyzed by use of Kolmogorov complexity which is a very important measure of the randomness of various events. In the inlet region
Masashi ICHIMIYA +2 more
doaj +1 more source
The laminar-turbulent transition of a boundary layer induced by a jet injection in the inlet region of a circular pipe was experimentally investigated.
Masashi ICHIMIYA +3 more
doaj +1 more source
The laminar-turbulent transition of a boundary layer induced by jet flow ejection in the inlet region of a circular pipe was experimentally investigated.
Masashi ICHIMIYA +2 more
doaj +1 more source

