Results 11 to 20 of about 405,275 (266)
Microbiology and Molecular Biology Reviews, 1998 SUMMARY Insertion sequences (ISs) constitute an important component of most bacterial genomes. Over 500 individual ISs have been described in the literature to date, and many more are being discovered in the ongoing prokaryotic and eukaryotic genome-sequencing projects. The last 10 years have also seen some striking advances in
J, Mahillon, M, Chandler
openaire +2 more sources
New insertion site for Nexplanon insertion [PDF]
BMJ Sexual & Reproductive Health, 2019 In October 2018, Merck Sharp and Dohme (MSD) changed the advised area of the arm where Nexplanon should be inserted. They are doing this because of the very rare but serious complication of cardiovascular insertions. During the past 18 months, they have been discussing with anatomists and others where is the best place to insert Nexplanon that avoids ...
openaire +2 more sources
Conceptual Design of a HTS Dipole Insert Based on Bi2212 Rutherford Cable
Instruments, 2020 The U.S. Magnet Development Program (US-MDP) is aimed at developing high-field accelerator magnets with magnetic fields beyond the limits of Nb3Sn technology.
Alexander V Zlobin +2 more
doaj +1 more source
Inserting Videos Into Videos [PDF]
2019 IEEE/CVF Conference on Computer Vision and Pattern Recognition (CVPR), 2019 CVPR ...
Donghoon Lee 0004 +2 more
openaire +2 more sources
Applied Sciences, 2020 The importance of a reliable blade root connection has grown due to the higher-gravity-induced edgewise loads on the blade root that resulted from the recent increased size and weight of a wind turbine rotor blade.
Kwangtae Ha
doaj +1 more source
Novel 3D-Printed Cell Culture Inserts for Air–Liquid Interface Cell Culture
Life, 2022 In skin research, widely used in vitro 2D monolayer models do not sufficiently mimic physiological properties. To replace, reduce, and refine animal experimentation in the spirit of ‘3Rs’, new approaches such as 3D skin equivalents (SE) are needed to ...
Magdalena Bauer +5 more
doaj +1 more source
Optimization of load introduction points in sandwich structures with additively manufactured cores
Design Science, 2020 This paper presents how numerical optimization methods, like topology optimization, and new design possibilities through additive manufacturing (AM) can be used for structural improvements of the load introduction points in sandwich structures.
Johann Schwenke, Dieter Krause
doaj +1 more source
Personal Identification based on Multi Biometric Traits [PDF]
مجلة جامعة الانبار للعلوم الصرفة, 2017 The biometric system that based on single biometric measure (Unimodal) are usually contained variety of problems and limitation like noisy data, does not provide high security and non-university, so we used the multibiometric system to improve the ...
Wigdan J. Al-Kubaisy, Muzhir S. Al-Ani
doaj +1 more source
Can primary insert be used in revision knee prosthesis?
Medicine Science, 2021 The aim of osteoarthritis treatment is to reduce pain and relieve functional limitations. Total knee replacement is now frequently used in the ultimate treatment of osteoarthritis.
Omer Bozduman +3 more
doaj +1 more source
Journal of Engineering Technology and Applied Physics, 2021 The mapping industry is one of the areas that is always given attention to balance the rapid development of current technology. The application of Light Detection and Ranging (LiDAR) technology in the mapping industry opens up a wide ...
Hazri Hassan +1 more
doaj +1 more source