Results 271 to 280 of about 723,392 (313)
Some of the next articles are maybe not open access.
Performance Installation Effects for Nozzles Installed on a Twin-Jet Fighter Airplane Model
SAE Technical Paper Series, 1968<div class="htmlview paragraph">Wind tunnel tests were conducted at subsonic and transonic Mach numbers to determine the performance levels of exhaust nozzles installed in an aircraft. These tests were conducted with dual nozzles mounted in rigs simulating the entire airplane and with a single nozzle installed in a shaft-mounted rig simulating ...
D. L. Motycka, P. J. Skowronek
openaire +1 more source
Group effectiveness at an ERDA installation
Proceedings of the fifteenth annual SIGCPR conference on -, 1977This report is the product of a series of component objectives in studying organizational behavior. It is composed from personal involvement in the consultants group at LBL, and from interviews of the other members of the group and the immediate supervisor. The interviewed group was composed of nine consultants.I have conducted the interviews, analyzed
openaire +1 more source
Temperature Effects on Turbine Supercharger Installations
Journal of the Aeronautical Sciences, 1943In order to obtain consistent flight test data for airplanes with turbine superchargers, account must be taken of the variation of engine brake horsepower with changes in atmospheric conditions. The variation of power available with the change of free air temperature is greatly magnified by the complexity of the induction system when the turbine ...
openaire +1 more source
Installation and Viscosity Effects in Turbine Meters
NAFEMS International Journal of CFD Case Studies, 1998Turbine flow meters are commonly used in the oil industry. The rotor rotates freely and takes from the flowing fluid only the torque required to overcome its losses. The speed of rotation of the rotor is monitored with a pick-up which generates a pulse at the passing of each rotor blade. The calibration of the meter is presented as a curve of the meter'
A. Neal, D. McEwen
openaire +1 more source
Unsteady CFD Simulations of Propeller Installation Effects
42nd AIAA/ASME/SAE/ASEE Joint Propulsion Conference & Exhibit, 2006A series of unsteady CFD simulations have been conducted for a set of generic isolatedand installed-propeller configurations at low-speed flight conditions. The propeller geometry investigated is a four-bladed design typical of those used on modern regional turboprop aircraft.
openaire +3 more sources
EEC orifice plate programme — Installation effects
Flow Measurement and Instrumentation, 1991Abstract Results of an analysis of all data obtained in the EEC orifice plate programme under different installation conditions are presented. The programme was designed to test minimum straight length specifications for both the ISO 5167 and AGA Report No 3 standards.
openaire +1 more source
Cost-effective photoenergy installation
2014 55th International Scientific Conference on Power and Electrical Engineering of Riga Technical University (RTUCON), 2014Yevgen Sokol +5 more
openaire +1 more source
Installation of offshore wind turbines: A technical review
Renewable and Sustainable Energy Reviews, 2021Zhiyu Jiang
exaly