Results 71 to 80 of about 5,812 (219)

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

Advanced Electron Microscopy and Microcomputed Tomography Analysis of Single‐Crystal Ni‐Base Superalloys After Short‐Term Multiaxial Creep

Advanced Engineering Materials, EarlyView.
This work studies the anisotropic behavior of circular notched tensile specimens of Ni‐base superalloy single crystals during high‐temperature tensile creep along [001], [110], and [111]. Correlative scale‐bridging imaging of specimens reveals early rupture along [110] because 1) plastic deformation proceeds faster at notch center; 2) more (brittle ...
Leonardo Agudo Jácome, Lijie Cao, Christoph Somsen, Johannes Boes, René Hesse, Werner Theisen, Gunther Eggeler   +6 more
wiley   +1 more source

A model of strain hardening for stage IV based on lattice curvature induced dislocations and grain fragmentation

Journal of Materials Research and Technology
A new model is presented for the interpretation of the nearly linear Stage IV large strain hardening behavior observed in polycrystalline metals.
Laszlo S. Toth, Anthony D. Rollett
doaj   +1 more source

Influence of Scan Strategies in Electron Beam Powder Bed Fusion on Solidification, Microstructure, and High‐Temperature Compressive Properties of γ′‐Strengthened Inconel 738LC

Advanced Engineering Materials, EarlyView.
Experiments and thermophysical simulations were conducted to investigate the electron beam powder bed fusion electron beam (PBF‐EB/M) process for the γ′‐strengthened nickel‐based superalloy Inconel 738LC. The results demonstrate the impact of process‐induced microstructural variations on high‐temperature mechanical behavior, providing a basis for ...
Jan Niklas Petenati, Karthik Kumar Banku, Prasanth Bondi, Ivan Zhirnov, Yangyiwei Yang, Gordon Schmidt, Jürgen Christen, Georg Hasemann, Manja Krüger, Bai‐Xiang Xu, Bilal Gökce, Silja‐Katharina Rittinghaus   +11 more
wiley   +1 more source

Achieving High ON State Current through Ferroelectric Polarization‐Dependent Interfacial Resistance Switching in Undoped Orthorhombic HfO2 Films

Advanced Functional Materials, EarlyView.
Ferroelectric tunnel junction devices based on epitaxial undoped ferroelectric HfO2 films demonstrate stable switching endurance of over 106 switching cycles, low write voltages of ±3 V, 16 measured resistance states, and neuromorphic capability.
Markus Hellenbrand, Nuno Estrócio, Ji S. Kim, Babak Bakhit, Marian C. Istrate, Corneliu Ghica, Tiago Rebelo, Nives Strkalj, Abin Varghese, Bernardo Almeida, Luís S. Marques, Bipin Rajendran, Judith L. MacManus‐Driscoll, José P. B. Silva   +13 more
wiley   +1 more source

Strain Engineering of Magnetoresistance and Magnetic Anisotropy in CrSBr

Advanced Materials, EarlyView.
Biaxial compressive strain significantly enhances magnetoresistance and critical saturation fields in thin flakes of the 2D magnet CrSBr, along all three crystallographic axes. First‐principles calculations link these effects to strain‐induced increases in exchange interactions and magnetic anisotropy.
Eudomar Henríquez‐Guerra, Alberto M. Ruiz, Marta Galbiati, Álvaro Cortés‐Flores, Daniel Brown, Esteban Zamora‐Amo, Lisa Almonte, Andrei Shumilin, Juan Salvador‐Sánchez, Ana Pérez‐Rodríguez, Iñaki Orue, Andrés Cantarero, Andres Castellanos‐Gomez, Federico Mompeán, Mar Garcia‐Hernandez, Efrén Navarro‐Moratalla, Enrique Diez, Mario Amado, José J. Baldoví, M. Reyes Calvo   +19 more
wiley   +1 more source

Effect of post-annealing temperature on the microstructure, texture, and mechanical properties of a deformed ferrite-martensite stainless steel

Journal of Materials Research and Technology
This research explores the impact of annealing on the microstructure, texture, and mechanical behavior of asymmetrically rolled dual-phase stainless steel.
Hossein Aghamohammadi, Roohollah Jamaati, Valéria Mertinger, Erzsébet Nagy, Ali Amininejad   +4 more
doaj   +1 more source

Tuning Amorphous‐Crystalline Catalytic Interfaces by Mechanochemistry: Cu‐Based Metallic Glasses Coupled with Ceria for CO Oxidation

Advanced Materials, EarlyView.
Ball‐milling Cu‐based metallic glasses with ceria creates a unique nanostructure where metallic glass particles are wrapped by CeO2 nanoparticles. The intimate integration triggers copper state reorganization during reaction and aging, boosting CO oxidation and COPrOx activity.
Maahin Mirzay‐Shahim, Mehran Nabahat, Laia Pascua‐Solé, Isabel Serrano, Ilaria Lucentini, Xènia Garcia, Marina Armengol‐Profitós, Asier Agrelo‐Lestón, Ignasi Burgués‐Ceballos, Núria J. Divins, Ignacio J. Villar‐Garcia, Virginia Pérez‐Dieste, Carlos Escudero, Carlo Marini, Jordi Llorca, Eloi Pineda, Pere Bruna, Lluís Soler   +17 more
wiley   +1 more source

Study on the impact parameters of convective heat transfer in industrial-scale Siemens reactor

Case Studies in Thermal Engineering
In industrial-scale Siemens reactors, convective heat transfer (CHT) plays a crucial role in regulating the uniformity of the reactor's temperature distribution and ensuring the quality of the polysilicon products. This study developed a forced CHT model
Xingping Yuan, Dan Zhao, Yanqing Hou, Ni Yang, Wenhui Ma, Fengyang Chen, Gang Xie   +6 more
doaj   +1 more source

Air Oxidation Behavior of Two Ti-Base Alloys Synthesized by HIP

High Temperature Materials and Processes, 2016
The oxidation behavior of Ti-5Al-2.5Sn and Ti-6Al-4V produced by hot isostatic pressing (HIP) has been studied at 650–850°C in air for 24 h. The oxidation kinetics of both alloys followed the parabolic law with good approximation, except for Ti-5Al-2.5Sn
Liu S., Guo Q. Q., Liu L. L., Xu L., Liu Y. Y.   +4 more
doaj   +1 more source