Results 41 to 50 of about 63,296 (310)

Mechanochemical Synthesis and Characterization of Nanostructured ErB4 and NdB4 Rare‐Earth Tetraborides

open access: yesAdvanced Engineering Materials, Volume 27, Issue 6, March 2025.
ErB4 and NdB4 nanostructured powders are produced by mechanochemical synthesis. 5 h mechanical alloying and 4 M HCl acid leaching are used in the production. ErB4 and NdB4 powders exhibit maximum magnetization of 0.4726 emu g−1 accompanied with an antiferromagnetic‐to‐paramagnetic phase transition at about TN = 18 K and 0.132 emu g−1 with a maximum at ...
Burçak Boztemur   +5 more
wiley   +1 more source

Coulomb Spike Model of Radiation Damage in Wide Band-Gap Insulators

open access: yesQuantum Beam Science
A novel Coulomb spike concept is applied to the radiation damage induced in LiF and SiO2 with about the same mass density (~2.65 g cm−3) by Ni2860 and Kr3684 ions of 1.0-MeV u−1 energy for about the same electronic energy loss (~10 MeV µm−1).
Jean-Marc Costantini, Tatsuhiko Ogawa
doaj   +1 more source

Dynamics of surface charge and electric field distributions on basin-type insulator in GIS/GIL due to voltage polarity reversal

open access: yesHigh Voltage, 2020
In this study, a simulation model of surface charge accumulation has been established. The model considers three accumulation ways, i.e. electrical conduction within the gas, through insulator volume and along the insulator surface.
Yi Luo   +7 more
doaj   +1 more source

Topological Insulators for Thermoelectrics: A Perspective from Beneath the Surface [PDF]

open access: yes
Thermoelectric properties of topological insulators have traditionally been examined in the context of their metallic surface states. However, recent studies have begun to unveil intriguing thermoelectric effects emerging from bulk electronic states ...
G. Jeffrey, Snyder, Michael, Toriyama
core   +1 more source

Kondo insulators [PDF]

open access: yes, 1996
We discuss Kondo insulators in the context of recent experimental results. These experiments address the questions of the relationship of spin and charge excitations, the temperature dependence of the gap, and the existence of 'failed ...
Sarrao, JL   +6 more
core   +1 more source

Air‐Pressure–Actuated Vibroacoustic Metamaterial With Tunable Bandgap: Design, Modeling, and Characterization

open access: yesAdvanced Engineering Materials, EarlyView.
This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal   +2 more
wiley   +1 more source

Insulator defect detection based on improved Yolov5s

open access: yesFrontiers in Earth Science
The stable operation of a power supply system is inseparable from the work of detecting defects in transmission lines. However, the insulator defect detection model based on deep learning is widely used in wire inspection work.
Dehong Wei   +3 more
doaj   +1 more source

The insulator uncovered

open access: yesNature, 2001
Microscopes that reveal the structures of surfaces one atom at a time are good at imaging conductors but perform poorly with insulators. That may be about to change.
Pethica, J, Egdell, R
openaire   +1 more source

Electrochemical Behavior of Flame‐Sprayed Sc‐Doped AlCoCrFeMo High‐Entropy Alloy Coatings in 3.5% Sodium Chloride Solution

open access: yesAdvanced Engineering Materials, EarlyView.
Scandium (Sc)‐doped AlCoCrFeMo HEA coatings are fabricated via flame spraying with 0.1, 0.3, and 0.5 wt% Sc additions. Among these, the HEA‐Sc0.3 coating exhibits the highest corrosion resistance, indicated by a more positive corrosion potential and lower current density.
Pankaj Kumar   +7 more
wiley   +1 more source

ON THE NEED TO INCREASE THE RELIABILITY OF LINEAR INSULATORS FOR DISTRIBUTION NETWORKS 10-20 KV

open access: yesElectrical engineering & Electromechanics, 2018
Introduction. In Ukraine high voltage overhead distribution lines (OL) of class 6 and 10 kV are the most extended. Their total length exceeds 280,000 km. More than 95% of the lines are made on line supports from reinforced concrete racks. On all poles of
Yu. N. Shumilov   +2 more
doaj   +1 more source

Home - About - Disclaimer - Privacy