Results 111 to 120 of about 70,713 (291)
An Interfacial Area Transport Modeling for Two-Phase Flow in Small And Large Circular Pipes
, 2021 With the rapid development of the advanced two-phase flow experimental technologies, more experimental databases with extended measurement ranges have been established to support the two-phase flow model development.
Dang, Zhuoran
core
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Two-group interfacial area transport equation in large diameter pipes
, 2002 The closure relations for the two-group interfacial area transport equation (LATE) by which the changes of interfacial area concentration can be dynamically modeled are set forth in this thesis for the case of large diameter pipes.
Smith, Todd Ryan
core
Chemical Reaction Effect upon Gas–Liquid Interfacial Area in a Bubble Column Reactor
, 2013 This work analyses the influence of different experimental conditions over important hydrodynamic parameters of a bubble column reactor, such as bubble size distribution, gas hold-up and the gas–liquid interfacial area. The influence of gas flow-rate (18–
Diego Gómez-Díaz +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
FrictionThe lubrication conditions of friction pairs in water or aqueous solutions are crucial to the performance and lifespan of key mechanical components in engineering applications.
Anqi Huang, Ying Liu, Jia Cheng
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study explored how effective nickel aluminide coatings are obtained in providing oxidation resistance applied to the Inconel 738 alloy, modeling with diffusion models. In the present study, kinetics and thermal behavior of the Inconel 738 alloy were studied by the low‐temperature thermoreactive aluminizing process, which was carried out at 625°C ...
Gozde Celebi Efe +4 more
wiley +1 more source
One-group interfacial area transport equation for horizontal two-phase flow with 90-degree bend
, 2007 The two-fluid model is used in the current thermal-hydraulic system analysis codes to perform detailed assessment of nuclear reactor safety. One of the major shortcomings of the two-fluid model has been the lack of an accurate and dynamic closure ...
Callender, Kennard
core
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Effect of Greywater Irrigation on Air-Water Interfacial area in Porous Medium
, 2012 In this study, the effect of greywater irrigation on airwater interfacial area is investigated. Several soil column experiments were conducted for different greywater irrigation to develop the pressure-saturation curves.
Anwar, Faisal
core