Results 91 to 100 of about 4,055,516 (260)

129I interlaboratory comparison: phase I and phase II results [PDF]

, 1997
An interlaboratory comparison exercise for 129I was organized and conducted. A total of nine laboratories participated in the exercise to either a full or limited extent. In Phase I of the comparison, a suite of 11 samples were measured.
Proctor, I. D., Caffee, M. W., Roberts, M. I.   +2 more
core   +1 more source

Intelligent Continuum Micromachines in Complex Confined Spaces

SmartBot, EarlyView.
The cover depicts a conceptual design for an intelligent continuum micromachine entering a target capsule used in fusion‐energy research through its slender gas‐fill tube. By combining route‐adaptive deformation, embedded sensing, and a functional end effector, the robot could inspect hidden defects, assess local conditions, and support localized ...
Huayang Sai, Yunyue Yang, Shuxing Xu, Jinbo Hu, Jiliang Wang, Zhehao Gan, Wei Tang, Tian‐Yun Huang   +7 more
wiley   +1 more source

МЕЖЛАБОРАТОРНОЕ СРАВНЕНИЕ ЛАБОРАТОРИЙ ИЗМЕРЕНИЯ МАССЫ В ЛАТВИИ

The paper presents interlaboratory comparison of Latvian mass measurement laboratories using a set of reference weights from 100 mg to 20 kg. Their results have been compared with reference value established by project coordinator and information ...
Ivanova, Tatjana
core   +1 more source

Interlaboratory comparison of magnetic thin film measurements

Journal of Research of the National Institute of Standards and Technology, 2003
A potential low magnetic moment standard reference material (SRM) was studied in an interlaboratory comparison. The mean and the standard deviation of the saturation moment m s, the remanent moment m r, and the intrinsic coercivity H c of nine samples were extracted from hysteresis-loop measurements. Samples were measured by thirteen laboratories using
da Silva, F. C. S., Wang, C. M., Pappas, D. P.   +2 more
openaire   +2 more sources

Interlaboratory comparison: optical property classification of carbon-based films by ellipsometry

, 2017
The paper addresses the “INTERLABORATORY COMPARISON: OPTICAL PROPERTY CLASSIFICATION OF CARBON-BASED FILMS BY ELLIPSOMETRY” and the following points are discussed in more detail: Established classification for mechanical properties, Complementary ...
Beck, Uwe, Hiratsuka, M.
core  

Controlling Polymorphism and Particle Size in Zr‐Based Metal‐Organic Frameworks Through Preformed Nodes and Machine‐Learning‐Assisted Synthesis

Small, EarlyView.
Reproducible control over polymorphism and particle size remains a central challenge in the synthesis of metal–organic frameworks. An intrinsic coupling between framework topology and particle size is revealed for the NU‐1000 and NU‐901 polymorphs, limiting their independent control.
Vanessa Ramm, Nadine Schmaus, David Gryc, Niklas E. Gampf, E. Eja Petersen, Romy Ettlinger, Roland A. Fischer   +6 more
wiley   +1 more source

The analysis of reproducibility of selected test methods on basis of an interlaboratory comparison studies [PDF]

, 2011
W artykule omówione zostały cztery porównania międzylaboratoryjne zorganizowane przez Laboratorium Badań Surowców i Wyrobów Włókienniczych Instytutu Włókiennictwa, dotyczące akredytowanych metod badawczych: PM I: Wyznaczanie zmiany wymiarów po praniu i ...
Jasińska, I., Mokowińska, Z.
core  

Biomaterial Platforms for Spatiotemporal Control of mRNA Delivery in Tissue Engineering and Regenerative Medicine: Design Rules, Therapeutic Applications, and Translational Roadmap

Small, EarlyView.
Biomaterial platforms can control where and when mRNA‐encoded proteins are expressed to support tissue repair. This Review proposes a cargo–target–timing framework linking therapeutic function, target tissues and cells, and expression profiles with carrier and scaffold design.
Huachun Pan, Shumin Yang, Katarina Holubova, Huifang Yin, Hongbo Chen, Xintian Zheng, Xiangan Han, Jinqiu Zhang, Xueping Li, Hui Zhang, Xiaojun Cai, Václav Slovák, Lihong Zhang, Quan Mo, Quazi T. H. Shubhra   +14 more
wiley   +1 more source

Harnessing the nonthermal effects of ultrasound for cancer treatment: From mechanisms to applications

Smart Molecules, EarlyView.
Nonthermal ultrasound transforms acoustic energy into diverse therapeutic bioeffects through cavitation, mechanical stimulation, and physicochemical activation. This review discusses how acoustic parameters, biological mechanisms, and responsive materials interact to influence nonthermal ultrasound‐enabled cancer therapies. Mechanism‐guided engineering
Liu Wang, Huan Tang, Yue Pan, Mingle Li, Weijie Zhao, Kai Liu   +5 more
wiley   +1 more source

Design, Implementation, and Evaluation of Proficiency Testing in EMC Burst Immunity

IEEE Access
For the accreditation according ISO/IEC 17025, the participation in the interlaboratory comparisons and proficiency testing is required as long as there exist suitable reference devices and providers.
Emrah Tas
doaj   +1 more source