A control method for interleaved Boost PFC converter
In order to solve the problem of complexity of zero-crossing detection and distortion of input current waveform, a novel control method is proposed for interleaved Boost PFC converter operates in critical conduction mode. This method is based on a new switching voltage detection circuit. By detecting the drain-source voltage of MOS transistor, the zero
Lin Anna, Xie Yunxiang
openaire +1 more source
MODELING AND SIMULATION OF INTERLEAVED BUCK-BOOST CONVERTER WITH PID CONTROLLER [PDF]
-In this paper, the analysis and modeling of interleaved Buck-boost converter with PID controller is discussed.
E Arthika, G Shanmuga Priya
core
Semakin meningkatknya penggunaan energi terbarukan, berpengaruh besar terhadap perkembangan pesat pada penggunaan teknologi DC-DC Converter. Hal ini disebabkan pada penggunaan energi terbarukan diperlukan teknologi berupa Maximum Power Point Tracking ...
Ramadhani, M Syahrul
core
Interleaved Boost Converter Fed DC Machine with Zero Voltage Switching and PWM Technique
In this paper an interleaved boost converter with Zero voltage Switching (ZVS) and Pulse Width modulation (PWM) techniques are proposed. The interleaved boost converters are preferred widely for the high power circuits since it has less input current ...
R. Puviarasi, D. Dhanasekaran
core
High voltage ratio interleaved boost DC-DC converter for high power fuel cell application [PDF]
The application of fuel cell is increasing in the last years mainly due to the possibility of high efficient decentralized clean energy generation. Fuel cells are a potential power source for electric vehicle or distributed power generation system.
Samosir, Ahmad Saudi +2 more
core
This thesis proposes a novel interleaved voltage-doubler boost converter and uses digital average current control to achieve power factor correction. The proposed converter uses a two-phase interleaved circuit to reduce the current stresses on components
Huang, Bo-jia
core
A Novel Interleaved DC-DC Converter with Reduced Loss for Fuel Cell Vehicle Application
In this paper a novel four-leg interleaved DC-DC boost converter is proposed which is well suitable for fuel cell vehicles (FCV) application. The voltage stress of two switches of this converter is half of the conventional interleaved converters ...
M. Khalilzadeh, B. Asaei, M. R. Nikzad
doaj
Design of novel DC-DC interleaved boost converter for BLDC application. [PDF]
Preethiraj PM, Belwin Edward J.
europepmc +1 more source
Brayton-Moser passivity based controller for constant power load with interleaved boost converter. [PDF]
Nithara PV +5 more
europepmc +1 more source
Retraction Note: Development of grey wolf optimization based modified fast terminal sliding mode controller for three phase interleaved boost converter fed PV system. [PDF]
Krishnaram K +3 more
europepmc +1 more source

