Results 11 to 20 of about 426,522 (226)
Interleaved DC/DC Boost Converter with Coupled Inductors [PDF]
Advances in Electrical and Electronic Engineering, 2018 This paper deals with the analysis of boost interleaved DC-DC converter with a coupled inductor on the same magnetic core. The advantage of the coupled inductor over the non-coupled case is investigated.
Slavomir Kascak +3 more
doaj +2 more sources
Analysis of Four Phase Interleaved Boost Converter [PDF]
TRANSACTIONS ON ELECTRICAL ENGINEERING, 2020 This paper deals with analysis of the four phase interleaved DC-DC converter for higher power application. The interleaved topology is widely used due to its advantage as lower input current ripple which means volume reduction of the input capacitor. The current ripple equation of an input current for the boost operation mode and the ripple current in
Slavomír Kaščák +3 more
openaire +3 more sources
Interleaved, Multi-Switch, Multi-Phase Boost Converter For Battery Discharge Regulators [PDF]
E3S Web of Conferences, 2017 Non-isolated step-up voltage converters are commonly required as Battery Discharge Regulators (BDR’s). The Weinberg and boost derived topologies are traditionally employed in modules up to one or two kilowatts.
Sobrino-Manzanares Fernando +1 more
doaj +2 more sources
Impact of converter interface type on the protection requirements for DC aircraft power systems [PDF]
, 2012 The utilization of converter interfaces has the potential to significantly alter the protection system design requirements in future aircraft platforms.
Burt, Graeme +3 more
core +4 more sources
Design and Implementation of Interleaved Boost Converter [PDF]
International Journal of Engineering and Technology, 2017 This paper deals with the design and simulation of interleaved boost converter for sustainable nonconventional energy sources. Both low and high power application demands the use of DC/DC converter. Two Phase Interleaved DC-DC Boost converters have many advantages compared to conventional boost converter such as very less current ripple, high ...
Latha Shenoy K +2 more
openaire +1 more source
Energies, 2021 Increasing converter power density is a problem of topical interest. This paper discusses an interleaved approach of the efficiency increase in the buck-boost stage of an inverter with unfolding circuit in terms of losses in semiconductors, output ...
Artem Fesenko +5 more
doaj +1 more source
Design and Simulation of Interleaved Boost Converter
International Journal for Research in Applied Science and Engineering Technology, 2023 Abstract: In this project Interleaved Boost Converter (IBC) with modified inductor techniques is proposed. It reduces the current stress of the main circuit components, in addition to this itcan also reduces the ripple of the input current and output voltage. In this approach, it can be faster switching, reduce the size and cost with suitable impedance
Rahul Kumar, Mr. Anurag Khare
openaire +1 more source
IET Power Electronics, 2023 In Electric Vehicle (EV) application, voltage conversion is significant to obtain the desired operating voltage from the source voltage. A conventional boost converter can handle such applications, but it may add losses throughout the conversion process.
Ahmad Alzahrani +4 more
doaj +1 more source
Circuit Configurable Bidirectional DC-DC Converter for Retired Batteries
IEEE Access, 2021 Due to the rapid development and widespread usage of Electric Vehicles (EVs), there will be more and more retired batteries in the future. These retired batteries can be used in energy storage systems to stabilize smart grid operation with high ...
Jenhao Teng +3 more
doaj +1 more source
A Single-Phase Bidirectional AC/DC Converter for V2G Applications
Energies, 2017 This paper presents a single-phase bidirectional current-source AC/DC converter for vehicle to grid (V2G) applications. The presented converter consists of a line frequency commutated unfolding bridge and an interleaved buck-boost stage.
Tao Peng +8 more
doaj +1 more source