Results 141 to 150 of about 2,913 (212)

Analysis of Corrosion and Wall Perforation in the Heat Exchanger Made of AISI 316L Stainless Steel

open access: yesMaterials and Corrosion, EarlyView.
Elevated passivation temperature is identified as the dominant factor triggering localized corrosion and subsequent perforation of AISI 316L heat exchanger tubes. Electrochemical and complementary characterization results show that the alloy retains high resistance to general, pitting, and intergranular corrosion, indicating that failure primarily ...
Bojana Radojković   +7 more
wiley   +1 more source

Effect of Fe and Si Content on Microstructure and Properties of Al-Cu-Li Alloys. [PDF]

open access: yesMaterials (Basel)
Feng T   +11 more
europepmc   +1 more source

Multi‐Method Investigation of Intergranular Corrosion of the Aluminium Alloy EN AW‐2024 With Different Cooling Rates After Solution Heat Treatment—Metallography and Eddy Current Testing

open access: yesMaterials and Corrosion, EarlyView.
The corrosion resistance of heat‐treatable aluminium alloys depends directly on the applied heat treatment. This article discusses the relationship between cooling rate and intergranular corrosion sensitivity. The intergranular corrosion depths were determined by light microscopy of cross‐sections and correlated with both non‐destructive eddy current ...
Hanna Schulz   +3 more
wiley   +1 more source

Trapping the Excess Electron of FeB-Type CeSi by Hydrogenation ─ Formation of Ferromagnetic Hydrides CeSiHx (TC ≈ 24 K). [PDF]

open access: yesInorg Chem
Dorsch LY   +9 more
europepmc   +1 more source

Development of Calcium‐Based Coatings to Mitigate Vanadate Corrosion

open access: yesMaterials and Corrosion, EarlyView.
Ca‐rich coatings can suppress the corrosive attack of molten V2O5 by forming Ca2 V2 O7 and Ca V2 O6. For this, a large Ca‐reservoir is key to mitigate corrosion at 600°C and 700°C. ABSTRACT Vanadate corrosion occurs in devices powered by heavy fuel oil, such as stationary turbines.
Mark Alexander Ulherr   +5 more
wiley   +1 more source

Acoustic Activity of Intergranular Corrosion Sensitized AISI 304L in Double‐Loop Electrochemical Potentiodynamic Reactivation Test

open access: yesMaterials and Corrosion, EarlyView.
Intergranular corrosion of AISI 304L is analyzed, combining DLEPR test and AE. Slow scan rate polarization reveals time‐shifted and frequency‐dependent acoustic emission in the active region of the DLEPR curve, allowing a separation between passive oxide rupture, intergranular corrosion and pitting. ABSTRACT Intergranular corrosion (IGC) susceptibility
Alexander Kreisch   +2 more
wiley   +1 more source

Machine Learning‐Guided Design of Cu–Ni–Sn Alloys With Tailored Ni3Sn/Ni3Sn2 Precipitates

open access: yesMaterials Genome Engineering Advances, EarlyView.
To address the trade‐off between strength and conductivity in Cu–Ni–Sn alloys, this study proposes a new closed‐loop design strategy that integrates machine learning, thermodynamic calculations, and experimental verification from the perspective of “phase selectivity”, providing a new approach for multiphase control and synergistic improvement of multi‐
Fei Tan   +10 more
wiley   +1 more source

Home - About - Disclaimer - Privacy