Ionic Elastomer Interface for Low‐Pressure and Durable All‐Solid‐State Batteries
This work reports an ionically conductive elastomer that enables stable all‐solid‐state batteries(ASSBs)under low external pressure. The soft elastomeric matrix, integrated with a LiG3‐based conductive phase(lithium bis(trifluoromethanesulfonyl)imide and triethylene glycol dimethyl ether), simultaneously delivers high ionic conductivity and mechanical ...
Jiaxu Zhang +15 more
wiley +1 more source
Out-of-Plane Skew Effects on the Cyclic Performance of Column-Tree Steel Moment Connections. [PDF]
Kim GW, Hong JK.
europepmc +1 more source
A method for calculating the downslope sliding force of gently dipping bedding rock slopes while accounting for the uncertainty of rear-edge vertical fissures. [PDF]
Ren Z +5 more
europepmc +1 more source
Analysis of water-permeable fractured zone in weakly cemented overburden considering rock strain-softening. [PDF]
Xue S, Wang Q, Song Z.
europepmc +1 more source
Influence of non-stationarity in friction angle on the performance of the braced excavation system. [PDF]
Rafi KM, Ering P.
europepmc +1 more source
Influence of impeller configuration and operating parameters on granular mixing: a DEM investigation. [PDF]
Zhou ZH +9 more
europepmc +1 more source
Investigation into the mechanism of damage removal in the compaction zone using dynamic negative pressure perforation. [PDF]
Li F +5 more
europepmc +1 more source
Related searches:
Abstract The interplay between faulting and folding mechanisms has been recognised in extensional and contractional settings. Numerous investigations have documented that the analysis of structural aspects of fault-related folds is important for the exploration and exploitation of hydrocarbon resources and in seismic data interpretation.
Seyed ahmad alavi +2 more
exaly +2 more sources
Drained angle of internal friction from direct shear and triaxial compression tests
International Journal of Geotechnical Engineering, 2016The angle of internal friction of sands from direct shear tests and plane strain tests is reported to be higher by about 2–8° compared to the triaxial compression tests. However, information about the comparison for the case of fine grained soils is scarce in the literature.
Rakesh J Pillai, Robinson Retnamony
exaly +2 more sources

