Results 21 to 30 of about 28,169 (290)
Deformation curve caused by the change in the internal friction angle. [PDF]
, 2022 Deformation curve caused by the change in the internal friction angle.
Xingli Jia (13994009) +4 more
core +1 more source
Evaluating the Effect of Soil Particle Characterization on Internal Friction Angle [PDF]
American Journal of Engineering and Applied Sciences, 2021 One of the critical design parameters used in evaluating soil structure is the friction angle, derived from Mohr's Circle failure criterion. The soil friction angle is an engineering parameter estimated in the laboratory to quantify the soil shear strength in geotechnical applications. This paper indicates an experimental study investigating the impact
Arezou Rasti +3 more
openaire +1 more source
Geofluids, 2022 In this paper, the pullout factor and failure mode of circular anchor plate at an inclined angle with the horizontal ground under the normal stress are studied with the method of the upper bound finite element limit analysis. The effects of soil cohesion,
Yibo Luo +4 more
doaj +1 more source
Mutual influence of cross hatch angle and superficial roughness of honed surfaces on friction in ring-pack tribo-system [PDF]
, 2013 The cylinder bore surface texture, widely produced by the honing technique, is an essential factor for a good engine performance (friction, oil consumption, running-in, wear etc.).
EL MANSORI, Mohamed +3 more
core +1 more source
Failure Mechanism and Slope Factors for a Footing Resting on Slopes
Magazine of Civil Engineering, 2021 The behaviour of a footing affected significantly with the presence of the slope. The effect of slope on the bearing capacity, slope factor, and failure mechanism has been explored using limit analysis.
SHUKLA RAJESH PRASAD
doaj +1 more source
Applied Sciences, 2020 A three-dimensional combined finite-discrete element element method (FDEM), parallelized by a general-purpose graphic-processing-unit (GPGPU), was applied to identify the fracture process of rough concrete–rock joints under direct shearing.
Gyeongjo Min +7 more
doaj +1 more source
Effect of grain size distribution on the shear properties of sand
Frontiers in Materials, 2023 In this study, we investigated the effect of particle size distribution on the shear properties of sand. Direct shear tests were conducted using four types of sand samples with different particle size distributions obtained from standard sand produced by
Hong Guo +14 more
doaj +1 more source
Geotechnical Maps for Angle of Internal Friction of An-Najaf Soil-Iraq Using GIS [PDF]
, 2021 The angle of internal friction value (φ) is used to describe the soil resistance to shear failure. It is estimated experimentally either from Direct Shear Test or Triaxial Stress Tests.
Sohaib Kareem Al-Mamoori +3 more
core +2 more sources
Relationship between the Angle of Repose and Angle of Internal Friction for Agricultural Granular Materials [PDF]
, 1998 Tanzania Journal o Agriculture Science 1998, Vol. 1(2): pp 187-194The angles of repose and internal friction are important parameters which determine the flow characteristics of agricultural granular materials, such as flour, maize, beans, wheat ...
Kajuna, S.T.A.R., Rugenga, E.
core +4 more sources
Analysis of Internal Friction Angle and Cohesion Value for Road Base Materials in a Specified Gradation [PDF]
, 2020 Internal friction angle (φ) is one of the important parameter in a foundation engineering, especially in the stress distribution event. The higher value of the internal friction angle shows the higher of the material can withstand the lateral force ...
Mohamed, Azman +4 more
core +2 more sources