Results 181 to 190 of about 138,063 (253)

Influence of Si Content and Milling Duration on the Microstructure and Mechanical–Tribological Properties of AlCoCrFeNiSi High‐Entropy Alloys

Advanced Engineering Materials, EarlyView.
Si‐doped AlCoCrFeNi high‐entropy alloys are synthesized by mechanical alloying to reveal the effect of Si content and milling time on phase evolution, microstructural refinement, and tribological behavior. A transition from FCC to BCC structure, significant grain refinement, and enhanced hardness and wear resistance are achieved, with the 4 at% Si ...
Mustafa Okumuş, Mehmet Emin Demir, Sercan Özpınar   +2 more
wiley   +1 more source

MEMS electrochemical angular accelerometer: a paradigm shift for attitude detection and control in rotorcraft UAVs. [PDF]

Microsyst Nanoeng
Zhu M, Liu Q, Zhang H, Yang J, Hu L, Zhao W, Jiang H, Huo X, Lu Y, Chen J, Wang Y, Chen D, Wang J.   +12 more
europepmc   +1 more source

Triple Junctions as Dislocation‐Like Defects: The Role of Grain Boundary Crystallography Revealed by Experiment and Atomistic Simulation

Advanced Engineering Materials, EarlyView.
Grain boundary triple junctions are an essential ingredient of the microstructure of polycrystalline materials. In this study, a triple junction is observed using atomic‐resolution scanning transmission electron microscopy and characterized. Computer simulations reveal that the junction has a dislocation character that is determined by the joining ...
Tobias Brink, Saba Saood, Peter Schweizer, Jörg Neugebauer, Gerhard Dehm   +4 more
wiley   +1 more source

Dedicated and Reconfigurable Artificial Neurons and Synapses based on Two-Dimensional Materials for Efficient Neuromorphic Application. [PDF]

Nanomicro Lett
Chen D, Yu P, Li Y, Shang J, Wu H, Yao X, Tang X, Li C, Zhu M, Gao C, Sun J, Tian H, Deng T.   +12 more
europepmc   +1 more source

Microstructure, Thermal Transport, and Dry‐Sliding Tribology of Powder‐Metallurgy Al7075 Composites Reinforced With Sol–Gel‐Derived ZnO–rGO Hybrid Nanoparticles

Advanced Engineering Materials, EarlyView.
Sol–gel‐derived ZnO–rGO hybrid nanoparticles enable Al7075 powder‐metallurgy composites to achieve concurrent gains in hardness and thermal conductivity while markedly lowering friction and wear. The hybrid architecture couples ZnO‐based load support with rGO‐assisted lamellar sliding and heat spreading, revealing a promising route toward lightweight ...
Bunyamin Aksakal, Cevher Kursat Macit, Merve Ayık, Hakan Tutumlu   +3 more
wiley   +1 more source

Gemini: the first underground testbed for seismic isolation and inter-platform control in next-generation gravitational-wave detectors. [PDF]

Eur Phys J Plus
Andric T, Harms J, Caravella I, Angiolilli M, Cortis D, D'Ambrosio N, De Deo M, D'Incecco M, Di Ludovico A, Gerberding O, Lalli A, Lantz B, Leonzi L, Macolino C, Mittleman R, Mow-Lowry C, Orlandi D, Pirro S, Ricci M, Rollins J, Warner J.   +20 more
europepmc   +1 more source

Stretching the Printability Metric in Direct‐Ink Writing with Highly Extensible Yield‐Stress Fluids

Advanced Functional Materials, EarlyView.
This study introduces “drawability” as a new metric for assessing printability in direct‐ink writing, focusing on gap‐spanning performance and speed robustness. By designing yield‐stress fluids with high extensibility, we demonstrate that extensional strain‐to‐break significantly enhances printability.
Chaimongkol Saengow, Samya Sen, Joaquin Yus, Eliza E. Lovrich, Amanda G. Hoika, Kelly M. Chang, Arielle A. Pfeil, Nellie Haug, Amy J. Wagoner Johnson, Randy H. Ewoldt   +9 more
wiley   +1 more source

Jahn-Teller Distortions in Pseudo-Octahedral Low-Spin Ni(III) Complexes With O,O or N,N Bidentate Ligands: A DFT Study. [PDF]

J Comput Chem
Conradie J.
europepmc   +1 more source

All‐in‐One Analog AI Hardware: On‐Chip Training and Inference with Conductive‐Metal‐Oxide/HfOx ReRAM Devices

Advanced Functional Materials, EarlyView.
An all‐in‐one analog AI accelerator is presented, enabling on‐chip training, weight retention, and long‐term inference acceleration. It leverages a BEOL‐integrated CMO/HfOx ReRAM array with low‐voltage operation (<1.5 V), multi‐bit capability over 32 states, low programming noise (10 nS), and near‐ideal weight transfer.
Donato Francesco Falcone, Victoria Clerico, Wooseok Choi, Tommaso Stecconi, Folkert Horst, Laura Bégon‐Lours, Matteo Galetta, Antonio La Porta, Nikhil Garg, Fabien Alibart, Bert Jan Offrein, Valeria Bragaglia   +11 more
wiley   +1 more source

Ideal observer estimation for binary tasks with stochastic object models. [PDF]

Phys Med Biol
Xu J, Noo F.
europepmc   +1 more source