Results 61 to 70 of about 402,202 (279)
HYBRID TECHNIQUES TO SOLVE OPTIMIZATION PROBLEMS IN EIT
Informatyka, Automatyka, Pomiary w Gospodarce i Ochronie Środowiska, 2017 This paper presents the hybrid algorithm for identification the unknown shape of an interface to solve the inverse problem in electrical impedance tomography. The conductivity values in different regions are determined by the finite element method.
Tomasz Rymarczyk, Paweł Tchórzewski
doaj +1 more source
Modelling of SFRC using inverse finite element analysis
, 2006 A method of inverse finite element analysis is used to determine the constitutive relationship of SFRC in tension, using primary experimental data. Based on beam bending test results and results from pull-out tests, an attempt is made to explain the ...
Neocleous, K. +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Journal of Materials Research and Technology, 2023 The constitutive model plays a decisive role in the accuracy and reliability of the simulation results. Because the material flow characteristics obtained by the traditional experimental method are difficult to describe thermoplastic deformation behavior
Zichuan Zou +5 more
doaj +1 more source
Recursive integral method for transmission eigenvalues
, 2015 Recently, a new eigenvalue problem, called the transmission eigenvalue problem, has attracted many researchers. The problem arose in inverse scattering theory for inhomogeneous media and has important applications in a variety of inverse problems for ...
Huang, Ruihao +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.A numerical–experimental framework is developed for characterizing multi‐matrix fiber‐reinforced polymers (MM‐FRPs) combining epoxy and polyurethane matrices. Harmonic bending tests are integrated with finite element model updating (FEMU) to simultaneously identify elastic and viscoelastic material parameters.
Rodrigo M. Dartora +4 more
wiley +1 more source
Finite Element Method on Shape Memory Alloy Structure and Its Applications
Chinese Journal of Mechanical Engineering, 2019 It is significant to numerically investigate thermo-mechanical behaviors of shape memory alloy (SMA) structures undergoing large and uneven deformation for they are used in many engineering fields to meet special requirements.
Bo Zhou +3 more
doaj +1 more source
Maximum principle for the finite element solution of time dependent anisotropic diffusion problems
, 2013 Preservation of the maximum principle is studied for the combination of the linear finite element method in space and the $\theta$-method in time for solving time dependent anisotropic diffusion problems. It is shown that the numerical solution satisfies
Huang, Weizhang, Li, Xianping
core +1 more source
Advanced Engineering Materials, EarlyView.Geometry‐driven thermal behavior in wire‐arc additive manufacturing (WAAM) influences microstructural evolution during nonequilibrium solidification of a chemically complex Fe–Cr–Nb–W–Mo–C nanocomposite system. By comparing different deposits configurations, distinct entropy–cooling rate correlations, segregation, and carbide evolution are revealed ...
Blanca Palacios +5 more
wiley +1 more source
Identification of plastic constitutive parameters at large deformations from three dimensional displacement fields [PDF]
, 2012 The aim of this paper is to provide a general procedure to extract the constitutive parameters of a plasticity model starting from displacement measurements and using the Virtual Fields Method.
A Bertram +59 more
core +5 more sources