Results 71 to 80 of about 14,781 (299)
Study on an Improved Algorithm for Helical Gear Meshing Stiffness and Its Influencing Factors
Jixie chuandong, 2023 Based on the potential energy method, an algorithm for modifying the meshing stiffness of helical gears is proposed. This method considers the real machining of the tooth root transition curve, which is a trajectory line formed by the tip angle of the ...
Liu Ziqian +5 more
doaj
Discrete Mathematics, 2001 zbMATH Open Web Interface contents unavailable due to conflicting licenses.
openaire +2 more sources
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
Jixie chuandong, 2014 According to the theory of forming process,the involute gear tooth profile is used to design the profile of finger cutter and disc cutter. Calculation of involute gear tooth profile is always used during the machining process.
游朝阳 +4 more
doaj
Powder Optimization Strategies for Binder Jetting Printing of BaTiO3 and Ba0,6Sr0,4TiO3 Ceramics
Advanced Engineering Materials, EarlyView.Powder optimization is investigated to enable binder jetting of BaTiO3 and Ba0.6Sr0.4TiO3 ferroelectric ceramics. The antagonistic relationship between flowability and binder compatibility is addressed through binder impregnation of granulated powders and fumed silica addition to fine powders.
Fanny Pruvost +4 more
wiley +1 more source
Surface pitting fatigue life of noninvolute, low-contact-ratio gears [PDF]
Spur gear endurance tests were conducted to investigate the surface pitting fatigue life of noninvolute gears with low numbers of teeth and low contact ratios for use in advanced applications.
Townsend, Dennis P.
core +1 more source
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Jixie chuandong, 2011 Involute spline is used extensively in mechanical transmission.Connection mode,main standard,selector parameter of involute spline are introduced.Spline parameter calculation software base on AutoCAD is developed by VC++.NET and ObjectARX,which provides ...
张大勇
doaj
Involute composite design evaluation using global design sensitivity derivatives [PDF]
An optimization capability for involute structures has been developed. Its key feature is the use of global material geometry variables which are so chosen that all combinations of design variables within a set of lower and upper bounds correspond to ...
Hart, J. K., Stanton, E. L.
core +1 more source