Results 1 to 10 of about 1,489 (110)
Potential and limits of Fe-SMA for asphalt crack self-repair: a critical review on thermal FIT & active reinforcement [PDF]
Over the years, studies have shown that fatigue cracking, caused by repeated traffic loads and daily or seasonal thermal cycles, constitutes the most dominant form of degradation in bituminous pavements.
Michel Muanda Ntoto
doaj +2 more sources
A Review of Additively Manufactured Iron-Based Shape Memory Alloys
Iron-based shape memory alloys (Fe-SMAs), traditionally manufactured, are favored in engineering applications owing to their cost-effectiveness and ease of fabrication.
Qian Sun +4 more
doaj +3 more sources
Performance of Floor Isolation equipped with Shape memory alloys [PDF]
Today, there is an increasing interest in use of seismic isolation to protect the structures against earthquakes. The most common type of seismic isolation is called base isolation, in which the isolation layer is installed under foundations to separate ...
M. Asadi, M. Ghassemieh
doaj +1 more source
Solution treatment process is stepwise process in manufacturing of iron based shape memory alloy. It is well known that the grain size of austenite in the solution treatment condition depends on the austenitizing/solutionizing temperature.
M.K. El Fawkhry
doaj +1 more source
The work presented here aims at investigating the feasibility of iron-based Fe-SMA (shape memory alloy) reinforcement as an alternative to conventional steel reinforcement.
Priyanka Jadhav +2 more
doaj +1 more source
The Effect of Iron Addition on the Dry Sliding Wear and Corrosion Behavior of Cu Al Ni Shape Memory Alloy [PDF]
In this paper, dry sliding wear and corrosion behavior of Cu + 13wt% Al + 3.8 wt% Ni was prepared by powder metallurgy. Dry sliding wear has been studied based on pin on disk at constant velocity and constant sliding distance .Corrosion behavior in 5 wt%
Abdul Raheem . K. Abid Ali +1 more
doaj +1 more source
Microstructure and Thermomechanical Characterization of Fe-28Mn-6Si-5Cr Shape Memory Alloy
Iron-based shape memory alloys (SMAs) have been widely studied during the last years, producing new formulations with potential applications in civil engineering.
Antonio Collazo +3 more
doaj +1 more source
Recent Advancements in Development and Application of an Iron-based Shape Memory Alloy at Empa
The Fe-SMA developed at the Swiss Federal Laboratories for Materials Science and Technology (Empa) has an alloy composition of Fe–17Mn–5Si–10Cr–4Ni–1(V,C) and exhibits an excellent shape memory effect on heating at 160 °C or above.
Moslem Shahverdi +5 more
doaj +1 more source
Many existing concrete buildings worldwide require improvement in structural integrity. Previous research has proven the effectiveness of iron-based shape memory alloy (Fe-SMA or memory-steel) reinforcements for the prestressed strengthening of ...
Bernhard Schranz +3 more
doaj +1 more source
Magnetic Properties of FeNiCoAlTiNb Shape Memory Alloys
The magnetic properties of the new Fe41Ni28Co17Al11.5(Ti+Nb)2.5 (at. %) shape memory alloy system were studied in this work. The magnetic properties were characterized by thermo-magnetization and a vibrating sample magnetometer (VSM). In iron-based shape
Chau-Yi Tsai +3 more
doaj +1 more source

