Results 261 to 270 of about 3,648,080 (308)
Some of the next articles are maybe not open access.

Iron Loss and Iron Requirement

1983
Measurement of iron loss is technically difficult. Chemical iron balances require meticulous technique to avoid contamination, and they do not allow the differentiation between nonabsorbed iron and iron excreted through the gastrointestinal tract. Isotope techniques require knowledge of the distribution of the radioiron within the organism and the ...
openaire   +1 more source

Iron losses in turbogenerator teeth

Journal of Applied Physics, 1982
The flux density was measured in a typical tooth of a 500-MV A synchronous generator. Peak flux densities of 14.3, 16.9, and 21.2 kG were observed in an open circuit test at 80%, 100%, and 125% of rated voltage. The search coil voltage waveforms were rich in odd harmonics tending toward a square wave.
F. J. Young, H. L. Schenk
openaire   +1 more source

Iron losses in processing tailings

Journal of Mining Science, 2005
For ferruginous quartzite of the Mikhailovsk deposit, the features of mineral composition, iron occurrence, granulometric composition, and opening of phases of stage and total tailings of processing are considered. Extraction of hematite from tailings using combined concentration schemes is one of the variants of complex utilization of mineral source ...
T. N. Gzogyan   +3 more
openaire   +1 more source

Iron Deficiency and Hearing Loss

ORL, 2010
Cochlear changes were studied in 141 growing rats raised on a basic iron-deficient diet for 7–100 days; 130 rats served as normal or chronic anemia controls. Electrophysiological findings showed that the incidence of an auditory threshold elevation of more than 15 dB was 31.85 % in the iron-deficient rats, but it was unchanged in all the control ...
Ai-Hua Sun   +5 more
openaire   +1 more source

Iron Loss of the Inductors

2019
Since inductors used in power electronics circuits are magnetized under completely different conditions from sinusoidal alternating voltage/current, the manner of occurrence of iron loss is often greatly different. In this chapter, we clarify the difference between the magnetizing modes of the transformer and inductor used in the power electronics ...
openaire   +1 more source

Iron losses in direct-current machines

Proceedings of the American Institute of Electrical Engineers, 1916
The term iron loss, as used in connection with rotating machinery, is shown to cover a large number of losses, some of which actually do not lie in the iron itself. The term core loss should be used except when the losses are actually located in the iron itself.
openaire   +1 more source

Mechanical method of iron loss measurement in a rotational field and analysis of iron loss in a motor

Journal of Applied Physics, 1991
A mechanical method of iron loss measurement in a rotational field was developed and, using this method, the mechanism of iron losses of motor cores was investigated. Iron losses in rotational fields of angular velocity ω(rad/s) induce torque T  (Nm) in specimens, and the total losses are calculated from ωT.
openaire   +1 more source

LOSS OF IRON THROUGH THE SKIN

Journal of the American Medical Association, 1950
ABSTRACT To the Editor:— In your editorial "Recent Studies of Iron" (page 904, March 25, 1950) you called attention to large losses of iron in the sweat as reported by Mitchell and Hamilton (J. Biol. Chem.178: 345, 1949). We have recently studied the iron content of sweat obtained from 25 normal persons (Adams, Leslie and Levin: Dermal Loss of Iron, to
openaire   +1 more source

IRON LOSS AT MENSTRUATION

BJOG: An International Journal of Obstetrics & Gynaecology, 1964
F E, HYTTEN, G A, CHEYNE, A I, KLOPPER
openaire   +2 more sources

Home - About - Disclaimer - Privacy