Results 251 to 260 of about 3,447,567 (303)
Some of the next articles are maybe not open access.

Determination of laser damage thresholds by comparison with an absolute laser damage standard

Applied Physics Letters, 1981
Absolute laser-damage thresholds can be rapidly measured by comparison with an absolute laser-damage standard. Multiple-layer TiO2/SiO2 antireflection films on BK-7 glass were found to be the best available damage standards for use at 1064 nm.
D. Milam   +3 more
openaire   +1 more source

Laser damage in germanium

Optics & Laser Technology, 1975
Abstract We present a photographic study of areas of damage which occurred on a number of germanium etalons used as output mirrors of a pulsed CO 2 TEA laser. A search of the damage revealed certain characteristics which appeared at many locations on any particular etalon face, and on each of the several etalons used. The damage on the inside cavity
L.J. Willis, D.C. Emmony
openaire   +1 more source

Laser damage in silicon

Optics & Laser Technology, 1984
Abstract Laser damage in silicon has been investigated using single crystals of p-type Si with thin wafers of 0.325 mm thickness being exposed to Nd 3+ laser pulses. The laser was in a free generation mode, with wavelength 1.064 μm, and pulse duration time of 100 μs, with energy of 200 mJ pulse -1 .
M. Srećković, B. Vedlin, N. Backović
openaire   +1 more source

The Effect of Laser Annealing on Laser Induced Damage Threshold

Journal of Modern Optics, 1990
A significant enhancement of the single shot Laser Induced Damage Threshold of CaF2 and fused silica and a moderate enhancement for GaAs and Al has been observed as the result of laser annealing using an excimer laser operating at 248 nm. This phenomenon is primarily attributed to a reduction of the residual surface roughness of the samples.
N.C. Kerr, D.C. Emmony
openaire   +1 more source

Laser damage thresholds at short wavelengths

Conference on Lasers and Electro-Optics, 1981
A survey of single-pulse laser damage thresholds for a wide variety of commercially available film coatings and prepared surfaces is reported. Tests were conducted at 532, 355, and 248 nm. Pulses for the longer wavelengths, generated by harmonic conversion of 1064-nm light from a Nd:glass laser, had a duration of 0.7 nsec.
F, Rainer, T F, Deaton
openaire   +2 more sources

Threshold Damage From CO2 Lasers

Archives of Ophthalmology, 1969
Rabbit corneas have been exposed to radiation from a CO 2 laser emitting a spatially smooth beam. Energy densities of 1.2 Joules (J)/sq cm, 0.77 J/sq cm, and 0.55 J/sq cm were found to cause minimal damage to the cornea at exposure times of 55, 10, and 3.5 msec. At these levels damage was confined to the corneal epithelium and was manifested by a flat,
R R, Peabody   +4 more
openaire   +2 more sources

Laser damage threshold of KTiOPO_4

Applied Optics, 1989
Laser damage thresholds are reported for two unpoled and one poled KTiOPO(4) crystals under similar experimental conditions. For the TEM(00) mode of a Nd:YAG laser, the fluence and power density values for the unpoled crystals (23-33 J/cm(2) and 2-3 GW/cm(2), respectively) were higher than for the poled crystal (10-17 J/cm(2) and 0.8-1.3 GW/cm(2 ...
openaire   +2 more sources

Laser Damage in Semiconductors.

1977
Abstract : Experimental damage thresholds for Si, Ge, GaAs, GaAs(x)P(1-x) and GaP have been determined at 10.6 x 10 to the -6 and 1.06 x 10 to the -6 laser wavelengths. For CW CO(2) laser damage, all the thresholds are of the order of a few kW/cm(2) for an irradiation time of about 0.10 second.
W. W. Grannemann, S. K. Gulati
openaire   +1 more source

Surface Potential As A Laser Damage Diagnostic

SPIE Proceedings, 1985
We investigated the relationship between surface potential changes and N-on-1 laser surface damage on a wide range of materials. The surface potential or work function difference was measured as a function of position by a small non-contacting Kelvin type probe. This design and operation of the probe is described.
MF Becker   +3 more
openaire   +1 more source

Laser damage in glasses

British Journal of Applied Physics, 1965
Results are described which suggest that a laser beam focused inside a sample of glass produces a superheated liquid, and that the resulting internal pressure can only be released by internal fracturing, and, in some cases, also by fragmentation of the sample.
openaire   +1 more source

Home - About - Disclaimer - Privacy