Results 11 to 20 of about 287,305 (267)
Chinese Journal of Mechanical Engineering, 2021 The current research of narrow-gap gas metal arc welding (NG-GMAW) primarily focuses on improving the sidewall fusion and avoiding the lack-of-fusion defect. However, the high cost and operation difficulty of the methods limit the industrial application.
Guoqiang Liu +4 more
doaj +1 more source
Applied Sciences, 2021 High pressure multi-layer rolling is an effective method to reduce residual stress and distortion in metallic components built by wire arc additive manufacturing (WAAM).
Valeriy Gornyakov +3 more
doaj +1 more source
Scientific Reports, 2017 Periodic structures of alternating amorphous-crystalline fringes have been fabricated in silicon using repetitive femtosecond laser exposure (800 nm wavelength and 120 fs duration). The method is based on the interference of the incident laser light with
Yasser Fuentes-Edfuf +7 more
doaj +1 more source
Laser Powder Welding of a Ti52Al46.8Cr1Si0.2Titanium Aluminide Alloy at Elevated Temperature
High Temperature Materials and Processes, 2011 A method for the joining of a Ti52Al46.8Cr1Si0.2Titanium Aluminide alloy by laser powder welding is presented. The technique acts to join materials by consolidating powder with focused laser beam to form weld beads that fill a V joint.
Smal C. A., Meacock C. G., Rossouw H. J.
doaj +1 more source
Femtosecond laser induced thermophoretic writing of waveguides in silicate glass
Scientific Reports, 2021 Here in, the fs-laser induced thermophoretic writing of microstructures in ad-hoc compositionally designed silicate glasses and their application as infrared optical waveguides is reported.
Manuel Macias-Montero +7 more
doaj +1 more source
Metals, 2021 This study focuses on the influence of cooling conditions on the long-period stacking-ordered (LPSO) phase evolution and corrosion behavior of as-cast Resoloy®, a bioresorbable Mg-Dy-based alloy. Metallographic and corrosive tests are used to monitor the
Sandra Ahlers +2 more
doaj +1 more source
Applied Sciences, 2017 Laser welding of thick plates in production environments is one of the main applications of high power lasers; however, the process has certain limitations.
Anna Unt +4 more
doaj +1 more source
Materials & Design, 2022 Post-build rolling can mitigate residual stress (RS) and distortion in large-scale components built by wire arc additive manufacturing (WAAM). In this study, based on numerical simulations that considered both WAAM deposition and vertical rolling, the ...
Valeriy Gornyakov +3 more
doaj +1 more source
CFD MODEL OF LASER ADDITIVE MANUFACTURING PROCESS OF CYLINDERS
South African Journal of Industrial Engineering, 2017 A theoretical approach based on a numerical simulation using experimental data is proposed as a contribution to the study of laser-based additive manufacturing by direct energy deposition (DED).
Tamsaout, Toufik +4 more
doaj +1 more source
Low-cycle Fatigue and Fracture Behaviour of 9%Ni Steel Flux Cored Arc Welding joint at Cryogenic Temperature [PDF]
MATEC Web of Conferences, 2019 In the present work, low-cycle fatigue (LCF) test and crack tip opening displacement (CTOD) test were performed for 9% Ni steel flux cored arc welding (FCAW) joint at room temperature (296 K) and cryogenic temperature (80 K).
Mu Weidong +3 more
doaj +1 more source