Results 121 to 130 of about 1,271,779 (368)
Advanced Engineering Materials, EarlyView.Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
, 2001 We theoretically and experimentally analyze Q-switched cladding pumped ytterbium-doped fiber lasers designed for high pulse energies. We compare the extractable energy from two high-energy fiber designs: (1) single- or few-moded low-NA large mode area ...
Alvarez-Chavez, J.A. +7 more
core +1 more source
Modelling and Optimization of CO2 Laser Turning Process for Armored Steel Assisted by Oxygen [PDF]
, 2022 wisam faruk +4 more
openalex +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Linewidth and phase noise characteristics of DFB fibre lasers
, 2004 The anomalous linewidth behavior in a DFB fiber laser is investigated. It is shown that not only does the linewidth deviate drastically from the Schawlow-Townes linewidth formula by increasing with pump and laser power, but it also varies significantly ...
Voo, N.Y. +7 more
core +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
136.9 W Acousto‐Optically Q‐Switched 2 μm Thin‐Disk Laser
Advanced Photonics ResearchWe demonstrate an acousto‐optic (AO) Q‐switching Ho:YAG thin disk laser (TDL) at 2 μm with Tm‐fiber laser pumping. Under continuous‐wave operation, the laser delivered a maximum output power of 216.4 W with an optical‐to‐optical efficiency of 43.28 ...
Qiongwen Zhang +11 more
doaj +1 more source
A Workflow to Accelerate Microstructure‐Sensitive Fatigue Life Predictions
Advanced Engineering Materials, EarlyView.This study introduces a workflow to accelerate predictions of microstructure‐sensitive fatigue life. Results from frameworks with varying levels of simplification are benchmarked against published reference results. The analysis reveals a trade‐off between accuracy and model complexity, offering researchers a practical guide for selecting the optimal ...
Luca Loiodice +2 more
wiley +1 more source