Results 261 to 270 of about 11,144,592 (297)
Some of the next articles are maybe not open access.

Stress Analysis of Lifting and Lowering-In Process

Volume 1: Design and Construction; Environment; Pipeline Automation and Measurement, 2014
For typical cross-country pipelines not expected to experience ground movement hazards, the longitudinal stresses experienced during lifting and lowering-in are typically the highest that they experience in their entire service life. Vertical bending stresses are produced by the curvature created from the upward lifting forces of the sidebooms and the ...
Fan Zhang   +3 more
openaire   +1 more source

Lift-off process for noble metals

Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 1993
A two-layer lift-off process using aluminum and an inorganic dielectric for patterning noble metals is described. It produces a smoothly sloped metallization pattern and is compatible with the deposition temperatures up to 350 °C. The metal layers can be deposited either by evaporation or by sputtering.
Karel Domanský   +2 more
openaire   +1 more source

Lift-off process for nanoimprint lithography

Microelectronic Engineering, 2003
We report a novel a lift-off method for nanoimprint lithography. This is a bi-layer method, using a polymethyl methacrylate (PMMA) on lift-off layer (LOL) resist scheme. For the imprint step, direct evidence for good pattern transfer down to 20 nm is shown. Oxygen plasma ashing is required to remove residual PMMA.
P. Carlberg   +5 more
openaire   +1 more source

Basic research on micro processing characteristics of reverse lift-off process

2018 International Symposium on Micro-NanoMechatronics and Human Science (MHS), 2018
In micro electromechanical systems(MEMS) technology, lift-off processes are general patterning methods for the formation of amorphous alloy thick film structures. However, thicknesses of structures fabricated in this method are not uniform and cross-sectional shapes are not flat because sputtered particles are blocked by the sidewalls of the lift-off ...
Yuki Nakagawa   +5 more
openaire   +2 more sources

A Methodology for Modeling Lift as a Modulated Process

Journal of Offshore Mechanics and Arctic Engineering, 1996
Abstract This paper presents a methodology for using a modulated process to model the lift forces induced on circular cylinders by an oscillating flow. The generalization of the existing quasi-steady flow model leads to techniques which apply the Hilbert transform in model evaluation and parameter determination. Analysis of measured lift
openaire   +1 more source

A Note on A Lifting Property for Convex Processes

1988
Abstract Let E and F be locally convex spaces, and T be an open multi-valued map from E to F such that its graph is a closed cone in E x F and kernel ker T complete metrizable, then we show that each compact subset of F is contained in the image by T of a compact subset of E.
K.F. Ng, L.S. Liu
openaire   +1 more source

Optimal tracking control of artificial gas-lift process

Computers & Chemical Engineering, 2018
Abstract Artificial gas-lift (AGL) technique is commonly used to enhance oil production when the reservoir pressure in wells is not enough to sustain acceptable oil flow rate. However, the gas-lift wells are prone to instability, characterized by regular oscillations of pressure and flow. This phenomenon is known as casing-heading instability.
Jing Shi, Ahmed Al-Durra, Igor Boiko
openaire   +2 more sources

Identification of the Parameters of a Discrete Gas-Lift Process

Journal of Computer and Systems Sciences International, 2022
Aliev, F. A.   +4 more
openaire   +2 more sources

Simulation of the Exoskeletons Group Work During Load Lifting Process

2022
Sergey Jatsun   +2 more
exaly  

Home - About - Disclaimer - Privacy