Results 111 to 120 of about 614,448 (304)
, 2012 When a liquid melt is cooled, a glass or phase transition can be obtained depending on the cooling rate. Yet, this behavior has not been clearly captured in energy landscape models.
D. Chandler +4 more
core +1 more source
Thermophysical Properties of the Desulphurization Slags With Various CaS and CaO/Al2O3 Ratio
Advanced Engineering Materials, EarlyView.This article investigates how CaS content and the CaO/Al2O3 ratio influence the thermophysical properties of desulphurization slags. Using experimental measurements and thermodynamic simulations, this study reveals complex effects on viscosity, surface tension, and density, providing new insight into slag structure and phase behavior under ...
Eldar Salpagarov +4 more
wiley +1 more source
EnergiesElectric vehicles are increasingly seen as a viable alternative to conventional combustion-engine vehicles, offering advantages such as lower emissions and enhanced energy efficiency.
Sara El Afia +3 more
doaj +1 more source
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
International Journal of Rotating Machinery, 2004 This article attempts to provide a cooling performance comparison of various mass transfer cooling methods and different cooling media through two experiments.
J. H. Wang, J. Messner, H. Stetter
doaj +1 more source
A paradigm shift in liquid cooling by multitextured surface design. [PDF]
Innovation (Camb), 2022 Zhou Y, Zhu P.
europepmc +1 more source
Method of intercalating large quantities of fibrous structures [PDF]
, 1991 A method of intercalating large quantities of fibrous structures uses a rotatable reaction chamber containing a liquid phase intercalate. The intercalate liquid phase is controlled by appropriately heating, cooling, or pressurizing the reaction. Rotation
Gaier, James R.
core +1 more source
Advanced Engineering Materials, EarlyView.The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Experimental Study on the Cooling Rate of a New Type of Oocyte Carriers
Zhileng xuebao, 2016 Cooling rate is the key factor that determines the cryopreserving effect of cells, which has much to do with the forms and the usages of freezing carrier.
Li Weijie +5 more
doaj
Optimization of the Heat Dissipation Performance of a Lithium-Ion Battery Thermal Management System with CPCM/Liquid Cooling. [PDF]
Materials (Basel), 2022 Zeng X, Men Z, Deng F, Chen C.
europepmc +1 more source