Results 81 to 90 of about 140,853 (266)
The study presents biodegradable and recyclable mixed‐matrix membranes (MMMs), hydrogels, and cryogels using luminescent nanoscale metal‐organic frameworks (nMOFs) and biopolymers. These bio‐nMOF‐MMMs combine europium‐based nMOFs as probes for the status of the materials with the biopolymers agar and gelatine and present alternatives to conventional ...
Moritz Maxeiner +4 more
wiley +1 more source
Probability of hyperthermia in a hot environment while wearing a liquid cooling garment underneath firefighters' protective clothing. [PDF]
Aljaroudi AM +5 more
europepmc +1 more source
Numerical simulation of liquid film cooling on hypersonic oblique plate
Near-space vehicles encounter significant aerodynamic heating challenges. Liquid films are considered a promising thermal protection approach due to their efficient cooling capabilities. This study numerically investigated the liquid film cooling process
Fangqi Shao +6 more
doaj +1 more source
Shellac, a centuries‐old natural resin, is reimagined as a green material for flexible electronics. When combined with silver nanowires, shellac films deliver transparency, conductivity, and stability against humidity. These results position shellac as a sustainable alternative to synthetic polymers for transparent conductors in next‐generation ...
Rahaf Nafez Hussein +4 more
wiley +1 more source
Fast‐Responding O2 Gas Sensor Based on Luminescent Europium Metal‐Organic Frameworks (MOF‐76)
Luminescent MOF‐76 materials based on Eu(III) and mixed Eu(III)/Y(III) show rapid and reversible changes in emission intensity in response to O2 with very short response times. The effect is based on triplet quenching of the linker ligands that act as photosensitizers. Average emission lifetimes of a few milliseconds turn out to be mostly unaffected by
Zhenyu Zhao +5 more
wiley +1 more source
3D‐Printed Sulfur‐Derived Polymers With Controlled Architectures for Lithium‐Sulfur Batteries
Rheology‐guided formulation design for direct ink writing enables the fabrication of 3D sulfur copolymer cathodes with controlled architectures for lithium‐sulfur batteries. The printed electrodes exhibit multiscale porosity and high sulfur utilization, delivering enhanced electrochemical performance compared to conventional cast electrodes.
Bin Ling +7 more
wiley +1 more source
The Equations of Movement and Energy Stream of a Liquid in Cooling System of the Engine
Results of theoretical research movement of a liquid in channels cooling system of the engine are presented. The equations movement of a liquid in channels with a various arrangement are received.
A.I. Yakubovich , V.E. Tarasenko
doaj
Herein presented supraparticles combine the nanoparticulate photocatalyst graphitic carbon nitride with the enzyme horseradish peroxidase, which is immobilized on silica nanoparticles. In an optimized compatibility range, both catalysts operate effectively within the hybrid supraparticles and catalyze a cascade reaction consisting of the photocatalytic
Bettina Herbig +11 more
wiley +1 more source
MOFs and COFs in Electronics: Bridging the Gap between Intrinsic Properties and Measured Performance
Metal‐organic frameworks (MOFs) and covalent organic frameworks (COFs) hold promise for advanced electronics. However, discrepancies in reported electrical conductivities highlight the importance of measurement methodologies. This review explores intrinsic charge transport mechanisms and extrinsic factors influencing performance, and critically ...
Jonas F. Pöhls, R. Thomas Weitz
wiley +1 more source
In Situ Study of Resistive Switching in a Nitride‐Based Memristive Device
In situ TEM biasing experiment demonstrates the volatile I‐V characteristic of MIM lamella device. In situ STEM‐EELS Ti L2/L3 ratio maps provide direct evidence of the oxygen vacancies migrations under positive/negative electrical bias, which is critical for revealing the RS mechanism for the MIM lamella device.
Di Zhang +19 more
wiley +1 more source

