Results 11 to 20 of about 229,690 (293)
Biosignal Amplifiers Based on Low‐Noise Organic Transistors with Printed Electrodes
Advanced Electronic Materials, 2023 The monitoring of microvolt‐level biosignals such as electroencephalograms requires the application of low‐noise signal amplifier circuits, which, for single‐use cases, must be fabricated for disposability using low‐cost manufacturing techniques.
Tomoharu Kimura +5 more
doaj +1 more source
Applied Sciences, 2023 We present a low-intensity noise single-frequency Yb-doped all-fiber amplifier oriented to space-borne gravitational wave detection. Relative intensity noise (RIN) below −70 dBc/Hz @ 1 mHz~1 Hz was achieved by virtue of feedback-loop-based intensity ...
Zaiyuan Wang +5 more
doaj +1 more source
UWB-MMIC Matrix Distributed Low Noise Amplifier
Proceedings, 2020 In this paper, a 3.1–11 GHz ultra-wideband low noise amplifier with low noise figure, high power gain S21, low reverse gain S12, and high linearity using the OMMIC ED02AH process, which employs a 0.18 μm Pseudomorphic High Electron Mobility Transistor is
Moustapha El Bakkali +4 more
doaj +1 more source
Design of BDS-3 RDSS low noise amplifier based on millimeter wave tube
Dianzi Jishu Yingyong, 2020 The existing Beidou signal receiver has a low-noise amplifier scheme in the S-band, and the noise figure is between 1.5 dB～1.7 dB under the condition of meeting the gain requirements and the noise performance can be further optimized.
Huang Shijin, Lai Songlin, Wang Yunan
doaj +1 more source
Design of CMOS-Based Unit Channel of Beamforming Transceivers for FACS Applications
IEEE Access, 2023 In this study, we designed the unit channel of beamforming transceivers for flexible access common spectrum (FACS) applications. The designed unit channel consisted of power amplifier, low noise amplifier, gain amplifier, attenuator, phase shifter, and ...
Seongjin Jang +5 more
doaj +1 more source
Applied Sciences, 2020 This paper presents a low-noise chopper operational amplifier using a lateral PNP input stage with bipolar junction transistor (BJT) current mirror base current cancellation.
Hyungseup Kim +8 more
doaj +1 more source
Study on the Technology of Ultra-high Sensitive Wide-band Magnetic-feedback Inductive Magnetic Sensor [PDF]
MATEC Web of Conferences, 2020 It analyses the composition and principle of high-sensitive wide-band magnetic-feedback inductive magnetic sensor to fulfil the demand of high-sensitive wide-band magnetic sensor in geological exploration.
Liu Yong +6 more
doaj +1 more source
FET input voltage amplifier for low frequency noise measurements
Metrology and Measurement Systems, 2020 The paper presents a low noise voltage FET amplifier for low frequency noise measurements. It was built using two stages of an op amp transimpedance amplifier.
Krzysztof Achtenberg +2 more
doaj +1 more source
Аdaptive broadband low-noise RF amplifier
Доклады Белорусского государственного университета информатики и радиоэлектроники, 2020 Adaptive broadband low-noise radio frequency amplifiers (ABLNRFA) are widely used in the construction of systems for protecting radio receiving paths from nonlinear damage in a non-stationary electromagnetic environment (EME).
I. Yu. Malevich, P. V. Zayats
doaj +1 more source
Designing a Low-Power LNA and Filter for Portable EEG Acquisition Applications
IEEE Access, 2021 A circuit with a low-power low-noise amplifier and a Gm-C ultra-low-power filter is proposed in this paper for portable electroencephalogram (EEG) acquisition applications.
Marzieh Moradi +2 more
doaj +1 more source