Results 91 to 100 of about 15,296,121 (237)
Quantifying the decarbonization potential of mobile heat battery in low-temperature district heating [PDF]
This research assesses the potential of a mobile thermochemical storage system, the mobile heat battery (M-HB), for decarbonizing a low-temperature district heating (DH) system in the Netherlands. The assessment is built on a case study where the M-HB is used to transport waste heat from different sources to a neighborhood interface of a DH system ...
Shuwei Wang +3 more
openaire +2 more sources
Experiments and thermophysical simulations were conducted to investigate the electron beam powder bed fusion electron beam (PBF‐EB/M) process for the γ′‐strengthened nickel‐based superalloy Inconel 738LC. The results demonstrate the impact of process‐induced microstructural variations on high‐temperature mechanical behavior, providing a basis for ...
Jan Niklas Petenati +11 more
wiley +1 more source
One of the most challenging aspects of a new district heating (DH) design is its general performance, which will determine the ecological and economic impacts of the investment.
Ciapała Bartłomiej +2 more
doaj +1 more source
Domestic heating accounts for 64% of domestic energy usage in the UK, yet there are currently very few viable options for low carbon residential heating.
Michael-Allan Millar +2 more
doaj +1 more source
Schematic representation of modes of microcrack nucleation, growth and temporary arrestment at different boundaries, with the criteria for crack propagation in three scenarios: (1) large notch, (2) defect/small sharp notch, and (3) long crack. This work revisits and integrates results on the fatigue behavior of advanced bainitic steels (in particular ...
Lucia Morales‐Rivas
wiley +1 more source
Postbuild annealing systematically modifies the phase fractions and morphology of EB‐PBF processed Mo–9Si–8B. Quantitative microstructure–property correlations reveal how controlled phase evolution enhances high‐temperature compressive strength and creep resistance.
Christopher Schmidt +5 more
wiley +1 more source
This article investigates the dependence of the properties on the manufacturing orientation in the form of the inclination angle to the build plate of LPBF‐fabricated NiTi rods with a diameter of 150–220 µm. Metallographic, chemical, thermal, and mechanical characterization show behavior under identical manufacturing conditions that ranges from ...
Sandra Herzig +2 more
wiley +1 more source
Entropy‐Driven Design of Low‐Melting‐Point Alloys via Compositionally Complex Strategy
Conventional low‐melting‐point alloys (LMPAs) are limited by a narrow compositional space and inherent property trade‐offs. This review presents an entropy‐driven design strategy that overcomes these limitations, ushering in a new class of low‐melting‐point compositionally complex alloys (LMCCAs).
Yinghui Shang +6 more
wiley +1 more source
Development of advanced low-temperature heat transfer fluids for district heating and cooling [PDF]
The feasibility of adding phase change materials (PCMs) and surfactants to the heat transfer fluids in district cooling systems was investigated. It increases the thermal capacity of the heat transfer fluid and therefore decreases the volume that needs to be pumped. It also increases the heat transfer rate, resulting in smaller heat exchangers.
openaire +2 more sources
Efficient heat distribution in solar district heating systems
This paper contains a short analysis showing the main benefit for solar district heating when a novel heat distribution concept with low temperatures is applied.
Werner, Sven, Averfalk, Helge
core +2 more sources

